25860D
1.INSPECT NO. 2 VACUUM SWITCHING VALVE ASSEMBLY
Slide the hose clip and disconnect the No. 1 air hose from the No. 2 vacuum switcing valve assembly.
Move the shift lever to P and apply the parking brake.
Connect the GTS to the DLC3, and then turn the ignition switch to ON.
Enter the following menus: Powertrain / Engine and ECT / Active Test / Activate the Brake Ejector VSV.
| Tester Display |
|---|
| Activate the Brake Ejector VSV |
Start the engine.
Using the GTS, turn off the No. 2 vacuum switcing valve assembly (Brake Ejector VSV: CLOSE).
Use your finger to confirm that the No. 2 vacuum switcing valve assembly has no suction.
Using the GTS, turn on the No. 2 vacuum switcing valve assembly (Brake Ejector VSV: OPEN).
Use your finger to confirm that the No. 2 vacuum switcing valve assembly has suction.
Connect the No. 1 air hose to the No. 2 vacuum switcing valve assembly and slide the hose clip to secure it.