Refer to Service Bulletin for the installation position of the transponder key ECU assembly.
45209
1.REMOVE STEERING SLIDING YOKE SUB-ASSEMBLY
| *a | Matchmark |
Put matchmarks on the No. 2 steering intermediate shaft assembly and steering sliding yoke sub-assembly.
Remove the bolt and steering sliding yoke sub-assembly from the No. 2 steering intermediate shaft assembly.
45260
2.REMOVE NO. 2 STEERING INTERMEDIATE SHAFT ASSEMBLY
| *a | Alignment Mark |
| *b | Slit |
Check that the slit of the No. 2 steering intermediate shaft assembly is aligned with the alignment mark of the steering column assembly.
Remove the bolt and No. 2 steering intermediate shaft assembly from the steering column assembly.
69057A
3.REMOVE IGNITION SWITCH LOCK CYLINDER AND KEY SET (w/o Smart Entry and Start System)
Secure the steering column assembly in a vise using aluminum plates.
Do not overtighten the vise.
Using a drill, drill a hole in the steering lock set bolt and insert a screw extractor.
Using the screw extractor, remove the steering lock set bolt and ignition switch lock cylinder and key set.
84052
4.REMOVE UNLOCK WARNING SWITCH ASSEMBLY (w/o Smart Entry and Start System)
Insert the key.
Disengage the 2 claws to remove the unlock warning switch assembly.
Slide the unlock warning switch assembly, in the direction shown by the arrow in the illustration, to remove it.
85432
5.REMOVE KEY INTERLOCK SOLENOID (except Manual Transaxle without Smart Entry and Start System)
Remove the screw.
Disengage the claw to remove the key interlock solenoid from the upper steering column bracket assembly.
84450
6.REMOVE IGNITION OR STARTER SWITCH ASSEMBLY (w/o Smart Entry and Start System)
Disengage the 2 claws to remove the ignition or starter switch assembly from the upper steering column bracket assembly.
Be sure to start operation while the ignition or starter switch assembly faces upward, and while the upper steering column bracket assembly faces downward.
45020A
7.REMOVE STEERING LOCK ACTUATOR ASSEMBLY (w/ Smart Entry and Start System)
Secure the steering column assembly in a vise using aluminum plates.
Do not overtighten the vise.
Using a drill, drill a hole in the steering lock set bolt and insert a screw extractor.
Using the screw extractor, remove the steering lock set bolt and steering lock actuator assembly from the steering column assembly.
80960
8.REMOVE POWER STEERING MOTOR ASSEMBLY
Do not drop the power steering motor assembly, strike it with tools or subject it to impacts.
If the power steering motor assembly is subjected to an impact, replace it with a new one.
Do not pull the wire harness of the power steering motor assembly.
Do not allow any moisture to come into contact with the power steering motor assembly.
Do not allow any foreign objects to contaminate the steering column assembly and the power steering motor assembly.
Do not loosen any bolts not mentioned in the procedure.
Cut the 3 clamps and remove the 3 clamps from the steering column assembly.
Remove the 2 bolts and power steering motor assembly from the steering column assembly.