If the following conditions are detected while the cruise control system is controlling vehicle speed, the system clears the vehicle speed stored in the ECM and cancels cruise control system control of vehicle speed.
| Vehicle Condition | Auto Cancel Condition | Re-operation Condition |
|---|---|---|
·
Cruise control indicator light goes off*1 ·
A warning message "Cruise control malfunction Visit your dealer" is displayed*1 ·
"Pong" warning sound is heard*1 ·
Cruise control indicator light illuminates in amber*2 |
·
Open or short in stop light switch circuit ·
Problem with vehicle speed signal |
Cruise control system is turned off and back on again using the cruise control main switch (ON-OFF button). |
·
Problem with stop light switch input circuit ·
Problem with cruise control main switch cancel circuit ·
Malfunction in the brake control system ·
Communication stop between skid control ECU (brake actuator assembly) and ECM |
Ignition switch is turned off and back to ON again. | |
| Cruise control indicator light remains illuminated in green (Cruise control system control of vehicle speed is canceled) | ·
Vehicle speed is lower than low speed limit (approximately 40 km/h (25 mph)) while driving with cruise control system controlling vehicle speed ·
VSC system operates while driving with cruise control system controlling vehicle speed*3 ·
TRC operates for certain amount of time while driving with cruise control system controlling vehicle speed*3 ·
TRC and VSC are off*3 |
Cruise control main switch is pushed to +/RES. |
| Vehicle speed is lower than stored speed by approximately 16 km/h (10 mph) or more | Cruise control main switch is pushed to -/SET. | |
| Cruise control indicator light goes out | Problem with throttle position sensor or motor | Cruise control system is turned off and back on again using the cruise control main switch (ON-OFF button). |
*1: w/ Multi-information Display
*2: w/o Multi-information Display
*3: w/ VSC