Home › Steering › POWER ASSIST SYSTEMS › POWER STEERING SYSTEM(for TMT Made) › 2017.10–2018.01
RM30M0E _55 Steering _017103 POWER ASSIST SYSTEMS _0333397 POWER STEERING SYSTEM(for TMT Made) C

POWER ASSIST SYSTEMS  POWER STEERING SYSTEM(for TMT Made)  C1541  Vehicle Speed Signal  C1542  Vehicle Speed Signal Malfunction  C1571  Speed Sensor Malfunction (Test Mode DTC)  


DESCRIPTION

The power steering ECU assembly receives vehicle speed signals from the skid control ECU (brake actuator assembly) via CAN communication. The ECU provides appropriate assist force in accordance with the vehicle speed based on the signals.

DTC No. Detection Item DTC Detection Condition Trouble Area Warning Indicate Return-to-normal Condition Note
C1541 Vehicle Speed Signal Vehicle speed signals via CAN communication are cut off for 3 seconds or more.
·

Brake control system

·

CAN communication system

·

Power steering ECU assembly


EPS warning light: Comes on The ECU judges the system has returned to normal or the ignition switch is turned ON again -
C1542 Vehicle Speed Signal Malfunction Vehicle speed signals via CAN communication are cut off for 3 seconds or more.
·

Brake control system

·

CAN communication system

·

Power steering ECU assembly


EPS warning light: Does not come on The ECU judges the system has returned to normal or the ignition switch is turned ON again -
C1571 Speed Sensor Malfunction (Test Mode DTC) Vehicle speed signals via CAN communication are cut off for 3 seconds or more.
·

Brake control system

·

CAN communication system

·

Power steering ECU assembly


EPS warning light: Does not come on After test mode separation and after normal confirmation -

CAUTION / NOTICE / HINT

NOTICE:

If the power steering ECU assembly has been replaced, perform assist map writing and torque sensor zero point calibration.

Click hereSteering>POWER ASSIST SYSTEMS>POWER STEERING SYSTEM(for TMT Made)>CALIBRATION


PROCEDURE

1.CHECK CAN COMMUNICATION SYSTEM

Result:
Result Proceed to
DTC U0129 is not output. A
DTC U0129 is output. B



A

2.CHECK BRAKE CONTROL SYSTEM

B

GO TO CAN COMMUNICATION SYSTEM (HOW TO PROCEED WITH TROUBLESHOOTING)

2.CHECK BRAKE CONTROL SYSTEM
a.

Using the GTS, check for DTCs and confirm that there are no malfunctions in the brake control system.

Click hereBrake>BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS>VEHICLE STABILITY CONTROL SYSTEM>DTC CHECK / CLEAR

Chassis > ABS/VSC/TRAC > Trouble Codes
50001 105

Result:
Result Proceed to
DTCs are not output. A
DTCs are output. B



A

REPLACE POWER STEERING ECU ASSEMBLY

B