Home › Vehicle Interior › HEATING / AIR CONDITIONING › AIR CONDITIONING SYSTEM(for Automatic Air Conditioning System) › 2017.10–2018.01
RM30M0E _58 Vehicle Interior _017118 HEATING / AIR CONDITIONING _0086573 AIR CONDITIONING SYSTEM(for Automatic Air Conditioning System) C

HEATING / AIR CONDITIONING  AIR CONDITIONING SYSTEM(for Automatic Air Conditioning System)  B1441  Air Mix Damper Control Servo Motor Circuit (Passenger Side)  


DESCRIPTION

The air mix damper servo sub-assembly sends pulse signals to indicate the damper position to the air conditioning amplifier assembly. The air conditioning amplifier assembly activates the motor (normal or reverse) based on these signals to move the air mix damper servo sub-assembly to the appropriate position. This adjusts the amount of air passing through the heater core after passing the evaporator and controls the temperature of the output air. The air conditioning amplifier assembly communicates with the servo through a communication/driver IC and wiring assembly called the air conditioning harness assembly.

DTC No. Detection Item DTC Detection Condition Trouble Area Memory
B1441 Air Mix Damper Control Servo Motor Circuit (Passenger Side) Air mix damper position sensor value does not change even if air conditioning amplifier assembly operates air mix damper servo sub-assembly
·

Air mix damper servo sub-assembly

·

Air conditioning harness assembly

·

Air conditioning amplifier assembly


Memorized
(30 seconds or more)*1

*1: The air conditioning amplifier assembly stores this DTC if the malfunction has occurred for the period of time indicated in the brackets.


WIRING DIAGRAM

E278112E09
0.677,4.292 2.042,4.667 1.365,0.375 10 false Air Mix Damper Servo Sub-assembly 2.948,4.313 4.49,4.698 1.542,0.385 10 false Air Conditioning Harness Assembly 5.365,4.448 6.917,4.833 1.552,0.385 10 false Air Conditioning Amplifier Assembly 5.365,4.25 5.583,4.448 0.219,0.198 10 false z2 5.563,1.313 5.781,1.51 0.219,0.198 10 false 4 5.563,2.188 5.781,2.385 0.219,0.198 10 false 3 5.552,3.219 5.771,3.417 0.219,0.198 10 false 2 5.792,1.438 6.333,1.635 0.542,0.198 10 false B BUS 5.792,2.375 6.333,2.573 0.542,0.198 10 false BUS 5.792,3.323 6.333,3.521 0.542,0.198 10 false BUS G 0.75,5.271 2.5,5.479 1.75,0.208 10 false : LIN Communication Line

CAUTION / NOTICE / HINT

HINT:

Confirm that no mechanical problem is present because this DTC can be output when either a damper link or damper is mechanically locked.


PROCEDURE

1.READ VALUE USING GTS
a.

Connect the GTS to the DLC3.


b.

Turn the ignition switch to ON.


c.

Turn the GTS on.


d.

Operate the set temperature switch.


e.

Enter the following menus: Body Electrical / Air Conditioner / Data List.


f.

According to the display on the GTS, read the Data List.

Body Electrical > Air Conditioner > Data List
Tester Display Measurement Item Range Normal Condition Diagnostic Note
Air Mix Servo Targ Pulse(D) Air mix damper servo sub-assembly target pulse Min.: 128
Max.: 383
for LHD
·

MAX COLD: 257 (pulse)

·

MAX HOT: 183 (pulse)


for RHD
·

MAX COLD: 255 (pulse)

·

MAX HOT: 329 (pulse)


-
Air Mix Servo Actual Pulse(D) Air mix damper servo sub-assembly actual pulse Min.: 128
Max.: 383
for LHD
·

MAX COLD: 257 (pulse)

·

MAX HOT: 183 (pulse)


for RHD
·

MAX COLD: 255 (pulse)

·

MAX HOT: 329 (pulse)


-
Body Electrical > Air Conditioner > Data List
Tester Display
Air Mix Servo Targ Pulse(D)
50003 121 70
Body Electrical > Air Conditioner > Data List
Tester Display
Air Mix Servo Actual Pulse(D)
50003 121 128
OK:

The display is as specified in the normal condition column.



Result:
Result Proceed to
OK (When troubleshooting according to Problem Symptoms Table) A
OK (When troubleshooting according to the DTC (for TMMIN Made)) B
OK (When troubleshooting according to the DTC (for TMT Made)) C
NG D



A

B

C

D

2.PERFORM ACTIVE TEST USING GTS
2.PERFORM ACTIVE TEST USING GTS
a.

Connect the GTS to the DLC3.


b.

Turn the ignition switch to ON.


c.

Turn the GTS on.


d.

Enter the following menus: Body Electrical / Air Conditioner / Active Test.


e.

According to the display on the GTS, perform the Active Test.

Body Electrical > Air Conditioner > Active Test
Tester Display Measurement Item Control Range Diagnostic Note
Air Mix Servo Targ Pulse(D) Air mix damper servo sub-assembly pulse Min.: 128
Max.: 383
for LHD

Operates between 183 and 257 pulses


for RHD

Operates between 255 and 329 pulses


Body Electrical > Air Conditioner > Active Test
Tester Display
Air Mix Servo Targ Pulse(D)
50004 121 24

OK:

Recirculation damper servo sub-assembly operates normally.


Result:
Result Proceed to
OK (for TMMIN Made) A
OK (TMT Made) B
NG C



A

B

C

3.REPLACE AIR MIX DAMPER SERVO SUB-ASSEMBLY
3.REPLACE AIR MIX DAMPER SERVO SUB-ASSEMBLY
a.

Replace the air mix damper servo sub-assembly.

Click hereVehicle Interior>HEATING / AIR CONDITIONING>AIR CONDITIONING UNIT>DISASSEMBLY

HINT:

Since the air mix damper servo sub-assembly cannot be inspected while it is removed from the vehicle, replace the air mix damper servo sub-assembly with a new or known good one and check that the condition returns to normal.



b.

Check for the DTC.

Click hereVehicle Interior>HEATING / AIR CONDITIONING>AIR CONDITIONING SYSTEM(for Automatic Air Conditioning System)>DTC CHECK / CLEAR

NOTICE:

If the battery is disconnected, the past DTCs will be cleared.


Body Electrical > Air Conditioner > Trouble Codes
50001 121
Result:
Result Proceed to
DTC B1441 is output A
DTC B1441 is not output B




A

4.REPLACE AIR CONDITIONING HARNESS ASSEMBLY

B

END (AIR MIX DAMPER SERVO SUB-ASSEMBLY WAS DEFECTIVE)

4.REPLACE AIR CONDITIONING HARNESS ASSEMBLY
a.

Replace the air conditioning harness assembly.

Click hereVehicle Interior>HEATING / AIR CONDITIONING>AIR CONDITIONING UNIT>DISASSEMBLY

HINT:

Since the air conditioning harness assembly cannot be inspected while it is removed from the vehicle, replace the air conditioning harness assembly with a new or known good one and check that the condition returns to normal.



b.

Check for the DTC.

Click hereVehicle Interior>HEATING / AIR CONDITIONING>AIR CONDITIONING SYSTEM(for Automatic Air Conditioning System)>DTC CHECK / CLEAR

NOTICE:

If the battery is disconnected, the past DTCs will be cleared.


Body Electrical > Air Conditioner > Trouble Codes
50001 121
Result:
Result Proceed to
DTC B1441 is output (for TMMIN Made) A
DTC B1441 is output (for TMT Made) B
DTC B1441 is not output C




A

B

C

END (AIR CONDITIONING HARNESS ASSEMBLY WAS DEFECTIVE)