Home › Steering › POWER ASSIST SYSTEMS › POWER STEERING SYSTEM(for TMMIN Made) › 2017.10–2018.01
RM30M0E _55 Steering _017103 POWER ASSIST SYSTEMS _0333419 POWER STEERING SYSTEM(for TMMIN Made) U

POWER ASSIST SYSTEMS  POWER STEERING SYSTEM(for TMMIN Made)  FAIL-SAFE CHART  


When a problem occurs in the electronic power steering system, the power steering warning light in the combination meter assembly comes on and the ECU stops the steering power assist, maintains the amount of power assist at a constant level or reduces the amount of power assist to protect the system.

DTC Code Malfunction Fail-safe Operation
C1511 Torque sensor malfunction Assist force restricted or power assist stopped.
C1512
C1513
C1514
C1515
C1516
C1517
C1524 Motor malfunction
C1531 Power steering ECU malfunction
C1532
C1533 Temperature sensor malfunction in power steering ECU
C1534 EEPROM abnormal
C1535 Steering wheel location data error
C1541 Vehicle speed signal error Assist force restricted.
C1542
C1544 Engine speed signal error
C1545
C1551 IG power source voltage error Power assist stopped.
C1552 PIG power source voltage error
C1553 Overvoltage at IG and PIG terminals
C1554 Power source relay malfunction
C1555 Motor relay malfunction
C1581 Assist map mismatch written in power steering ECU assembly Controlled using current default map.

HINT:
·

The amount of power assist may be decreased to prevent the motor and ECUs from overheating if the steering wheel is continuously turned when the vehicle is either stopped or driven at a low speed, or if the steering wheel is kept at either full lock position for a long time. In such cases, the amount of power assist returns to normal if the steering wheel is not turned for approximately 10 minutes with the engine idling.


·

If the battery is not sufficiently charged or the voltage decreases temporarily, the amount of power assist will be reduced and the EPS warning light will come on. In such cases, the amount of power assist returns normal when the battery voltage recovers.