When a problem occurs in the system, the power source relay circuit and the motor relay circuit are shut off to stop the power assist. The ECU must be replaced when there is a problem with the relays because each relay is built into the ECU.
| DTC No. | Detection Item | DTC Detection Condition | Trouble Area | Return-to-normal Condition | Note |
|---|---|---|---|---|---|
| C1552 | PIG Power Supply Voltage Malfunction | A PIG power source circuit malfunction. | ·
EPS fuse ·
PIG power source circuit ·
Power steering ECU assembly |
Ignition switch turned to ON again or after system confirmed to be normal | Power Steering Warning Light comes on. |
| C1554 | Power Supply Relay Failure | A power source relay circuit malfunction. | ·
EPS fuse ·
PIG power source circuit ·
Power steering ECU assembly |
Ignition switch turned to ON again | Power Steering Warning Light comes on. |
If the power steering ECU assembly, electric power steering column sub-assembly or power steering motor assembly have been replaced, perform torque sensor zero point calibration.
Click hereSteering>POWER ASSIST SYSTEMS>POWER STEERING SYSTEM(for TMMIN Made)>CALIBRATION
Inspect the fuses for circuits related to this system before performing the following inspection procedure.
Turn the ignition switch off.
Connect the GTS to the DLC3.
Turn the ignition switch to ON.
Turn the GTS on.
Enter the following menus: Chassis / EMPS / Data List.
Select the item PIG Power Supply in the Data List and read the value displayed on the GTS.
| Tester Display | Measurement Item | Range | Normal Condition | Diagnostic Note |
|---|---|---|---|---|
| PIG Power Supply | Power source voltage to activate motor | Min.: 0.0 V
Max.: 25.5 V |
11 to 14 V | The engine is running and the power steering is operating. |
| Tester Display |
|---|
| PIG Power Supply |
A value within the range listed in the normal condition column is displayed on the GTS.
| Proceed to |
|---|
| OK |
| NG |
OK
NG
| *a | Rear view of wire harness connector
(to Power Steering ECU Assembly) |
Disconnect the power steering ECU assembly connector.
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| F11-1 (PIG) - Body ground | Always | 11 to 14 V |
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| F11-2 (PGND) - Body ground | Always | Below 1 Ω |
| Proceed to |
|---|
| OK |
| NG |
OK
NG