If the power steering ECU assembly determines that the motor power source voltage and IG voltage are not within the specified range, it stops the power assist as a fail-safe function.
| DTC No. | Detection Item | DTC Detection Condition | Trouble Area | Return-to-normal Condition | Note |
|---|---|---|---|---|---|
| C1553 | PIG Power Supply Overvoltage | Either condition is met:
·
PIG power source overvoltage. ·
IG power source overvoltage. |
·
EPS fuse ·
EPS-IG fuse ·
IG and PIG power source circuits ·
Power steering ECU assembly |
Ignition switch turned to ON again or after system confirmed to be normal | Power Steering Warning Light comes on. |
If the power steering ECU assembly, electric power steering column sub-assembly or power steering motor assembly have been replaced, perform torque sensor zero point calibration.
Click hereSteering>POWER ASSIST SYSTEMS>POWER STEERING SYSTEM(for TMMIN Made)>CALIBRATION
Inspect the fuses for circuits related to this system before performing the following inspection procedure.
| *a | Rear view of wire harness connector
(to Power Steering ECU Assembly) |
Disconnect the power steering ECU assembly connectors.
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Switch Condition | Specified Condition |
|---|---|---|
| F11-1 (PIG) - F11-2 (PGND) | Always | 11 to 14 V |
| F12-1 (IG) - F11-2 (PGND) | Ignition switch ON | 11 to 14 V |
| Proceed to |
|---|
| OK |
| NG |
OK
NG