DTC C1581 will be stored if the power steering ECU assembly determines that the assist map is not written in the ECU.
| DTC No. | Detection Item | DTC Detection Condition | Trouble Area | Return-to-normal Condition | Note |
|---|---|---|---|---|---|
| C1581 | Assist Map Number Un-Writing | Assist map not written in power steering ECU assembly. | Power steering ECU assembly | Ignition switch turned to ON again or after system confirmed to be normal | Power Steering Warning Light comes on. |
If the power steering ECU assembly, electric power steering column sub-assembly or power steering motor assembly have been replaced, perform torque sensor zero point calibration.
Click hereSteering>POWER ASSIST SYSTEMS>POWER STEERING SYSTEM(for TMMIN Made)>CALIBRATION
Clear the DTCs.
Check for DTCs.
DTCs other than C1581 are not output.
| Proceed to |
|---|
| OK |
| NG |
OK
NG