The cooler (solar sensor) thermistor is installed on the upper side of the instrument panel. It detects sunlight to control air conditioning control in AUTO mode. The output voltage from the cooler (solar sensor) thermistor varies in accordance with the amount of sunlight. When the sunlight increases, the output voltage increases. As the sunlight decreases, the output voltage decreases. The air conditioning amplifier assembly detects changes in the output voltage from the cooler (solar sensor) thermistor.
| DTC No. | Detection Item | DTC Detection Condition | Trouble Area | Memory |
|---|---|---|---|---|
| B14A2 | Driver Side Solar Sensor Short Circuit | Short in cooler (solar sensor) thermistor circuit | ·
Cooler (solar sensor) thermistor ·
Harness or connector between cooler (solar sensor) thermistor and air conditioning amplifier assembly ·
Air conditioning amplifier assembly |
Memorized
(4 seconds or more)*1 |
*1: The air conditioning amplifier assembly stores this DTC if the malfunction has occurred for the period of time indicated in the brackets.
Connect the GTS to the DLC3.
Turn the ignition switch to ON.
Turn the GTS on.
Enter the following menus: Body Electrical / Air Conditioner / Active Test.
According to the display on the GTS, read the Data List.
| Tester Display | Measurement Item | Range | Normal Condition | Diagnostic Note |
|---|---|---|---|---|
| Solar Sensor (D Side) | Cooler (solar sensor) thermistor | Min: 0
Max: 255 |
Cooler (solar sensor) thermistor value increase as brightness increases | - |
| Tester Display |
|---|
| Solar Sensor (D Side) |
The display is as specified in the normal condition column.
| Result | Proceed to |
|---|---|
| OK (When troubleshooting according to Problem Symptoms Table) | A |
| OK (When troubleshooting according to the DTC (for TMMIN Made)) | B |
| OK (When troubleshooting according to the DTC (for TMT Made)) | C |
| NG | D |
A
B
Click hereVehicle Interior>HEATING / AIR CONDITIONING>AIR CONDITIONING AMPLIFIER(for TMMIN Made)>REMOVAL
C
Click hereVehicle Interior>HEATING / AIR CONDITIONING>AIR CONDITIONING AMPLIFIER(for TMT Made)>REMOVAL
D
| *a | Front view of wire harness connector (to Cooler (Solar Sensor) Thermistor) |
Disconnect the cooler (solar sensor) thermistor connector.
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Switch Condition | Specified Condition |
|---|---|---|
| E1-1 (SS+) - E1-2 (SS-) | Ignition switch off | Below 1 V |
| E1-1 (SS+) - E1-2 (SS-) | Ignition switch ON | 4.75 to 5.25 V |
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Remove the cooler (solar sensor) thermistor.
Click hereVehicle Interior>HEATING / AIR CONDITIONING>SOLAR SENSOR>REMOVAL
Inspect the cooler (solar sensor) thermistor.
Click hereVehicle Interior>HEATING / AIR CONDITIONING>SOLAR SENSOR>INSPECTION
| Result | Proceed to |
|---|---|
| OK (for TMMIN Made) | A |
| OK (for TMT Made) | B |
| NG | C |
A
Click hereVehicle Interior>HEATING / AIR CONDITIONING>AIR CONDITIONING AMPLIFIER(for TMMIN Made)>REMOVAL
B
Click hereVehicle Interior>HEATING / AIR CONDITIONING>AIR CONDITIONING AMPLIFIER(for TMT Made)>REMOVAL
C
Disconnect the F3 air conditioning amplifier assembly connector.
Disconnect the E1 cooler (solar sensor) thermistor connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| F3-10 (S5-2) - E1-1 (SS+) | Always | Below 1 Ω |
| F3-33 (TSD) - E1-2 (SS-) | Always | Below 1 Ω |
| F3-10 (S5-2) or E1-1 (SS+) - Body ground | Always | 10 kΩ or higher |
| F3-33 (TSD) or E1-2 (SS-) - Body ground | Always | 10 kΩ or higher |
| Result | Proceed to |
|---|---|
| OK (for TMMIN Made) | A |
| OK (for TMT Made) | B |
| NG | C |
A
Click hereVehicle Interior>HEATING / AIR CONDITIONING>AIR CONDITIONING AMPLIFIER(for TMMIN Made)>REMOVAL
B
Click hereVehicle Interior>HEATING / AIR CONDITIONING>AIR CONDITIONING AMPLIFIER(for TMT Made)>REMOVAL
C