The air conditioning control assembly communicates with the air conditioning amplifier assembly through the LIN communication system.
If the LIN communication system malfunctions, the air conditioning amplifier assembly does not operate even if the air conditioning control assembly is operated.
| DTC No. | Detection Item | DTC Detection Condition | Trouble Area | Memory |
|---|---|---|---|---|
| B14B2 | Lost Communication with Front Panel LIN | Lost communication with air conditioning control assembly | ·
Harness or connector between air conditioning control assembly and power source ·
Harness or connector between air conditioning control assembly and body ground ·
LIN communication system ·
Air conditioning control assembly ·
Air conditioning amplifier assembly ·
Air conditioning harness circuit |
Memorized
(10 seconds or more)*1 |
*1: The air conditioning amplifier assembly stores this DTC if the malfunction has occurred for the period of time indicated in the brackets.
for TMMIN Made
for TMT Made
Inspect the fuses for circuits related to this system before performing the following procedure.
DTCs B1497 and B14B2 may be output simultaneously.
Check vehicle type.
| Result | Proceed to |
|---|---|
| for TMMIN Made | A |
| for TMT Made | B |
A
B
| *a | Front view of wire harness connector (to Air Conditioning Control Assembly) |
Disconnect the air conditioning control assembly connector.
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Switch Condition | Specified Condition |
|---|---|---|
| F4-8 (IG+) - Body ground | Ignition switch off | Below 1 V |
| F4-8 (IG+) - Body ground | Ignition switch ON | 11 to 14 V |
| Proceed to |
|---|
| OK |
| NG |
OK
NG
| *a | Front view of wire harness connector (to Air Conditioning Control Assembly) |
Disconnect the air conditioning control assembly connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| F4-5 (GND) - Body ground | Always | Below 1 Ω |
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Disconnect the F3 air conditioning amplifier assembly connector.
Disconnect the F4*1 or F171*2 air conditioning control assembly connector.
*1: for TMMIN Made
*2: for TMT Made
Measure the resistance according to the value(s) in the table below.
for TMMIN Made
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| F3-4 (LIN1) - F4-2 (LIN1) | Always | Below 1 Ω |
| F3-4 (LIN1) or F4-2 (LIN1) - Body ground | Always | 10 kΩ or higher |
for TMT Made
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| F3-4 (LIN1) - F171-6 (LIN1) | Always | Below 1 Ω |
| F3-4 (LIN1) or F171-6 (LIN1) - Body ground | Always | 10 kΩ or higher |
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Replace the air conditioning control assembly.
Since the air conditioning control assembly cannot be inspected while it is removed from the vehicle, replace the air conditioning control assembly with a new or known good one and check that the condition returns to normal.
Air conditioning control assembly operation returns to normal.
| Result | Proceed to |
|---|---|
| OK | A |
| NG (When troubleshooting according to Problem Symptoms Table) | B |
| NG (When troubleshooting according to the DTC) | C |
A
B
C
Confirm whether of DTC B1497 is output.
If the battery is disconnected, the past DTCs will be cleared.
| Result | Proceed to |
|---|---|
| DTC B1497 is not output (for TMMIN Made) | A |
| DTC B1497 is not output (for TMT Made) | B |
| DTC B1497 is output | C |
A
Click hereVehicle Interior>HEATING / AIR CONDITIONING>AIR CONDITIONING AMPLIFIER(for TMMIN Made)>REMOVAL
B
Click hereVehicle Interior>HEATING / AIR CONDITIONING>AIR CONDITIONING AMPLIFIER(for TMT Made)>REMOVAL
C
Check whether DTC B1497 procedure has been completed.
| Result | Proceed to |
|---|---|
| DTC B1497 check procedure has not been completed | A |
| DTC B1497 check procedure has been completed (for TMMIN Made) | B |
| DTC B1497 check procedure has been completed (for TMT Made) | C |
A
B
Click hereVehicle Interior>HEATING / AIR CONDITIONING>AIR CONDITIONING AMPLIFIER(for TMMIN Made)>REMOVAL
C
Click hereVehicle Interior>HEATING / AIR CONDITIONING>AIR CONDITIONING AMPLIFIER(for TMT Made)>REMOVAL
| *a | Front view of wire harness connector
(to Air Conditioning Control Assembly) |
Disconnect the air conditioning control assembly connector.
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Switch Condition | Specified Condition |
|---|---|---|
| F171-1 (IG+) - Body ground | Ignition switch off | Below 1 V |
| F171-1 (IG+) - Body ground | Ignition switch ON | 11 to 14 V |
| Proceed to |
|---|
| OK |
| NG |
OK
NG
| *a | Front view of wire harness connector
(to Air Conditioning Control Assembly) |
Disconnect the air conditioning control assembly connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| F171-8 (GND) - Body ground | Always | Below 1 Ω |
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Disconnect the F3 air conditioning amplifier assembly connector.
Disconnect the F4*1 or F171*2 air conditioning control assembly connector.
*1: for TMMIN Made
*2: for TMT Made
Measure the resistance according to the value(s) in the table below.
for TMMIN Made
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| F3-4 (LIN1) - F4-2 (LIN1) | Always | Below 1 Ω |
| F3-4 (LIN1) or F4-2 (LIN1) - Body ground | Always | 10 kΩ or higher |
for TMT Made
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| F3-4 (LIN1) - F171-6 (LIN1) | Always | Below 1 Ω |
| F3-4 (LIN1) or F171-6 (LIN1) - Body ground | Always | 10 kΩ or higher |
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Replace the air conditioning control assembly.
Since the air conditioning control assembly cannot be inspected while it is removed from the vehicle, replace the air conditioning control assembly with a new or known good one and check that the condition returns to normal.
Air conditioning control assembly operation returns to normal.
| Result | Proceed to |
|---|---|
| OK | A |
| NG (When troubleshooting according to Problem Symptoms Table) | B |
| NG (When troubleshooting according to the DTC) | C |
A
B
C
Confirm whether of DTC B1497 is output.
If the battery is disconnected, the past DTCs will be cleared.
| Result | Proceed to |
|---|---|
| DTC B1497 is not output (for TMMIN Made) | A |
| DTC B1497 is not output (for TMT Made) | B |
| DTC B1497 is output | C |
A
Click hereVehicle Interior>HEATING / AIR CONDITIONING>AIR CONDITIONING AMPLIFIER(for TMMIN Made)>REMOVAL
B
Click hereVehicle Interior>HEATING / AIR CONDITIONING>AIR CONDITIONING AMPLIFIER(for TMT Made)>REMOVAL
C
Check whether DTC B1497 procedure has been completed.
| Result | Proceed to |
|---|---|
| DTC B1497 check procedure has not been completed | A |
| DTC B1497 check procedure has been completed (for TMMIN Made) | B |
| DTC B1497 check procedure has been completed (for TMT Made) | C |
A
B
Click hereVehicle Interior>HEATING / AIR CONDITIONING>AIR CONDITIONING AMPLIFIER(for TMMIN Made)>REMOVAL
C
Click hereVehicle Interior>HEATING / AIR CONDITIONING>AIR CONDITIONING AMPLIFIER(for TMT Made)>REMOVAL