16361A
1.INSTALL FAN AND GENERATOR V BELT
| *A | w/o Air Conditioning System |
| *B | w/ Air Conditioning System |
| *1 | Crankshaft Pulley |
| *2 | Generator with Regulator Assembly |
| *3 | Engine Water Pump Assembly |
| *4 | Cooler Compressor Assembly |
Install the fan and generator V belt to each pulley.
If it is difficult to install the fan and generator V belt, perform the following procedure:
Install the fan and generator V belt on each pulley except the tensioner pulley as shown in the illustration.
Release the fan and generator V belt tension by turning the V-ribbed belt tensioner assembly counterclockwise, and install the fan and generator V belt on the tensioner pulley.
Install the backside of the fan and generator V belt on the V-ribbed belt tensioner pulley.
Check that the fan and generator V belt is properly installed to each pulley.
| *a | 5 mm Hexagon Wrench |
| *b | Turn |
Turn the V-ribbed belt tensioner assembly counterclockwise and remove the 5 mm hexagon wrench.
After installing the fan and generator V belt, check that it fits properly in the ribbed grooves. Confirm that the belt has not slipped out of the grooves on the bottom of the crankshaft pulley by hand.
51441C
2.INSTALL ENGINE UNDER COVER RH (w/o Metal Type Under Cover)
w/o Side Rail Reinforcement:
Install the engine under cover RH to the vehicle with the 2 bolts and 4 screws.
w/ Side Rail Reinforcement:
Install the engine under cover RH to the vehicle with the 3 clips.
Install the 2 bolts and 3 screws.
51405A
3.INSTALL NO. 1 ENGINE UNDER COVER SUB-ASSEMBLY (w/ Metal Type Under Cover)
51451A
4.INSTALL CENTER ENGINE UNDER COVER (w/ Metal Type Under Cover)