Home › Engine / Hybrid System › 2NR-FE ENGINE MECHANICAL › DRIVE BELT › from 2017.10
RM30M0E _51 Engine / Hybrid System _053933 2NR-FE ENGINE MECHANICAL _0262359 DRIVE BELT A

2NR-FE ENGINE MECHANICAL  DRIVE BELT  REMOVAL  


PROCEDURE

Hide 51441C 1.REMOVE ENGINE UNDER COVER RH (w/o Metal Type Under Cover)

a.

w/o Side Rail Reinforcement:

i.

Remove the 2 bolts, 4 screws and engine under cover RH from the vehicle.



b.

w/ Side Rail Reinforcement:

i.

Remove the 2 bolts and 3 screws.


ii.

Remove the 3 clips and engine under cover RH from the vehicle.



Hide 51451A 2.REMOVE CENTER ENGINE UNDER COVER (w/ Metal Type Under Cover)

Hide 51405A 3.REMOVE NO. 1 ENGINE UNDER COVER SUB-ASSEMBLY (w/ Metal Type Under Cover)

Hide 16361A 4.REMOVE FAN AND GENERATOR V BELT

a.
A383344C01
2.969,1.26 3.094,0.948 true 2.885,1.292 3.198,1.448 0.313,0.156 10 true *a 0.052,2.417 0.365,2.573 0.313,0.156 10 false *b
*a 5 mm Hexagon Wrench
*b Turn


Release the fan and generator V belt tension by turning the V-ribbed belt tensioner assembly counterclockwise, and remove the fan and generator V belt from each pulley.


b.

While turning the V-ribbed belt tensioner assembly counterclockwise, align the holes, and then insert a 5 mm hexagon wrench to the holes to secure the V-ribbed belt tensioner assembly.