Home › Vehicle Interior › SEAT BELT › FRONT SEAT INNER BELT ASSEMBLY › from 2017.10
RM30M0E _58 Vehicle Interior _017117 SEAT BELT _0092578 FRONT SEAT INNER BELT ASSEMBLY G

SEAT BELT  FRONT SEAT INNER BELT ASSEMBLY  INSPECTION  


PROCEDURE

Hide 73240 1.INSPECT FRONT SEAT INNER BELT ASSEMBLY (for Driver Side)

a.
B359881C06
0.125,0.073 0.438,0.271 0.313,0.198 10 false *a
*a Component without harness connected
(Front Seat Inner Belt Assembly (for Driver Side))


Check the resistance.

i.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
2 - 3 Driver seat belt unfastened Below 1 Ω
2 - 3 Driver seat belt fastened 10 kΩ or higher


If the result is not as specified, replace the front seat inner belt assembly (for driver side).



Hide 73230 2.INSPECT FRONT SEAT INNER BELT ASSEMBLY (for Front Passenger Side)

a.

w/ Seat Belt Warning System:

i.
B312256C04
0.125,0.094 0.438,0.292 0.313,0.198 10 false *a 0.156,2.521 0.469,2.719 0.313,0.198 10 false *b 1.604,2.99 1.917,3.188 0.313,0.198 10 false B 1.542,0.688 1.854,0.885 0.313,0.198 10 false A
*a Component without harness connected
(Front Seat Inner Belt Assembly (for Front Passenger Side))
*b Component without harness connected
(Occupant Detection Sensor (Separate Type Front Seat Cushion Pad))


Check the resistance.

1.

Measure the resistance according to the value (s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
A-3 - B-3 Always Below 1 Ω
A-2 - B-1 Tongue plate released Below 1 Ω
A-2 - B-1 Tongue plate fastened 10 kΩ or higher


If the result is not as specified, replace the front seat inner belt assembly.