Home › Steering › STEERING COLUMN › STEERING COLUMN ASSEMBLY(for TMT Made) › 2017.10–2018.01
RM30M0E _55 Steering _017104 STEERING COLUMN _0333490 STEERING COLUMN ASSEMBLY(for TMT Made) G

STEERING COLUMN  STEERING COLUMN ASSEMBLY(for TMT Made)  INSPECTION  


CAUTION / NOTICE / HINT

HINT:

Refer to Service Bulletin for the installation position of the transponder key ECU assembly.


PROCEDURE

Hide 1.INSPECT PRELOAD

a.

Inspect the preload.

i.

Secure the steering column assembly in a vise using aluminum plates and wooden blocks.

NOTICE:

Do not overtighten the vise.



ii.
C287505C01
0.771,1.51 1.094,1.646 true 0.771,0.833 1.615,1.083 true 0.583,1.396 0.771,1.552 0.188,0.156 10 false *a 0.448,0.729 0.802,0.896 0.354,0.167 10 false SST
*a Wooden Block


Using SST and a torque wrench, turn the steering main shaft at a constant rate of approximately 1 revolution every 4 seconds and measure the preload.

SST
09616-00011  

Standard preload:

0.72 to 1.42 N*m (8 to 14 kgf*cm, 7 to 12 in.*lbf)


If the preload is not as specified, replace the power steering motor assembly or electric power steering column sub-assembly with a new one.



Hide 2.INSPECT STEERING LOCK OPERATION

a.

Remove the key and check that the steering lock function is activated.


b.
C287053

Insert the key, turn the ignition switch to ACC and check that the steering lock function has been deactivated.

If there is any abnormality, replace the ignition switch lock cylinder and key set.


Hide 3.INSPECT STEERING COLUMN ASSEMBLY

a.
C235885

Check that the 2 bushings are securely installed to the steering column assembly.

If the bushings are deformed, missing or damaged, replace the steering column assembly with a new one.