1.INSPECT INTAKE SYSTEM
Perform "Inspection After Repairs" after repairing or replacing the intake system.
Click hereEngine / Hybrid System>2NR-FE ENGINE CONTROL>SFI SYSTEM>INITIALIZATION
for LHD:
Check that there is no air suction at the points shown in the illustration.
| *A | for CVT | - | - |
Check that there is no air suction at the points shown in the illustration.
| *A | for Manual Transaxle | - | - |
for RHD:
Check that there is no air suction at the points shown in the illustration.
| *A | for CVT | - | - |
Check that there is no air suction at the points shown in the illustration.
| *A | for Manual Transaxle | - | - |
2.PERFORM INITIALIZATION
Perform "Inspection After Repairs" after repairing or replacing the intake system.
Click hereEngine / Hybrid System>2NR-FE ENGINE CONTROL>SFI SYSTEM>INITIALIZATION