Continuously Variable Transaxle System
| Engine stall speed
|
D
|
2200 +/- 400 rpm
|
| Fluid pressure (Throttle valve fully opened)*1
|
Engine stall speed
2200 +/- 400 rpm
|
D
|
4.2 to 4.9 MPa (42.8 to 50.0 kgf/cm2, 609 to 711 psi)
|
| R
|
4.0 to 5.1 MPa (40.8 to 52.0 kgf/cm2, 580 to 740 psi)
|
| Time lag
|
N → D
|
Less than 1.2 seconds
|
| N → R
|
Less than 1.5 seconds
|
| Engine idle speed (A/C off)
|
N
|
680 to 780 rpm
|
| Shift schedule (D)
|
| Throttle valve position (100%)
|
40 km/h (25 mph)
|
4400 to 5000 rpm
|
| 70 km/h (43 mph)
|
5200 to 5900 rpm
|
| 100 km/h (62 mph)
|
5600 to 6300 rpm
|
| Throttle valve position (Constant opening angle)*2
|
40 km/h (25 mph)
|
800 to 1200 rpm
|
| 70 km/h (43 mph)
|
1100 to 1500 rpm
|
| 100 km/h (62 mph)
|
1500 to 2000 rpm
|
| Shift schedule (D)
|
| Kick down
|
Accelerator pedal fully depressed above 70 km/h (43 mph)
|
3000 rpm or more
|
| Lock-up point
|
Lock-up ON
(Accelerator pedal opening 10%)
|
D
|
5 to 30 km/h (3 to 19 mph)
|
Lock-up OFF
(Accelerator pedal opening 0%)
|
D
|
5 to 30 km/h (3 to 19 mph)
|
*1: Connect terminals 13 (TC) and 4 (CG) of the DLC3 when measuring the fluid pressure.
*2: Depress the accelerator pedal at a consistent angle to maintain the specified vehicle speed.
Continuously Variable Transaxle Fluid
| Dry fill
|
7.47 liters (7.9 US qts, 6.6 Imp. qts)
|
Toyota Genuine CVT fluid FE
|
Continuously Variable Transaxle Assembly
| CVT oil pump type T oil seal
|
Standard Depth
|
0 to 0.5 mm (0 to 0.0197 in.)
|
Torque Converter and Drive Plate
| Drive plate runout
|
Maximum
|
0.30 mm (0.0118 in.)
|
Front Differential Oil Seal
| Front drive shaft oil seal LH
|
Standard Depth
|
6.7 to 7.7 mm (0.264 to 0.303 in.)
|
| Front drive shaft oil seal RH
|
Standard Depth
|
1.5 to 2.5 mm (0.0591 to 0.0984 in.)
|
Revolution Sensor
| Transmission revolution sensor (NIN)
|
| Tester Connection
|
Condition
|
Specified Condition
|
| 1 (NIN-) - 2 (NIN+)
|
20°C (68°F)
|
560 to 680 Ω
|
| Transmission revolution sensor (NOUT)
|
| Tester Connection
|
Condition
|
Specified Condition
|
| 1 (NOTO) - 2 (NOTB)
|
Low Signal
|
4 to 8 mA
|
| High Signal
|
12 to 16 mA
|
Park/Neutral Position Switch
| Park/neutral position switch assembly
|
| Tester Connection
|
Condition
|
Specified Condition
|
| 4 (B) - 9 (L)
|
Shift lever in P or N
|
Below 1 Ω
|
| Shift lever not in P and N
|
10 kΩ or higher
|
| 1 (RB) - 3 (PL)
|
Shift lever in P
|
Below 1 Ω
|
| Shift lever not in P
|
10 kΩ or higher
|
| 1 (RB) - 2 (RL)
|
Shift lever in R
|
Below 1 Ω
|
| Shift lever not in R
|
10 kΩ or higher
|
| 1 (RB) - 8 (NL)
|
Shift lever in N
|
Below 1 Ω
|
| Shift lever not in N
|
10 kΩ or higher
|
| 1 (RB) - 7 (DL)
|
Shift lever in D or M
|
Below 1 Ω
|
| Shift lever not in D and M
|
10 kΩ or higher
|
Shift Lever
| Shift lock control unit assembly (w/o Smart entry and start system)
|
| Wire harness
|
| Tester Connection
|
Condition
|
Specified Condition
|
| 1 (ACC) - Body ground
|
Ignition switch ACC
|
11 to 14 V
|
| Ignition switch off
|
Below 1 V
|
| 4 (IG) - Body ground
|
Ignition switch ON
|
11 to 14 V
|
| Ignition switch off
|
Below 1 V
|
| 8 (STP) - Body ground
|
Brake pedal depressed
|
11 to 14 V
|
| Brake pedal released
|
Below 1 V
|
| 7 (E) - Body ground
|
Always
|
Below 1 Ω
|
| Key interlock solenoid operation signal
|
| 5 (KLS+) - Body ground
|
Ignition switch ACC and shift lever in P
|
Below 1 V
|
| Ignition switch ACC and shift lever not in P
|
11 to 14 V
|
| Shift lock solenoid
|
| 1 (SLS+) - 2 (SLS-)
|
Always
|
112 Ω
|
| 4 (P) - 3 (E2)
|
Shift lever in P
|
10 kΩ or higher
|
| Shift lever not in P
|
Below 1 Ω
|
| Shift lock control unit assembly (w/ Smart entry and start system)
|
| Wire harness
|
| Tester Connection
|
Condition
|
Specified Condition
|
| 4 (IG) - Body ground
|
Engine switch on (IG)
|
11 to 14 V
|
| Engine switch off
|
Below 1 V
|
| 8 (STP) - Body ground
|
Brake pedal depressed
|
11 to 14 V
|
| Brake pedal released
|
Below 1 V
|
| 7 (E) - Body ground
|
Always
|
Below 1 Ω
|
| Shift lock solenoid
|
| 1 (SLS+) - 2 (SLS-)
|
Always
|
112 Ω
|
| 4 (P) - 3 (E2)
|
Shift lever in P
|
10 kΩ or higher
|
| Shift lever not in P
|
Below 1 Ω
|
| Transmission control switch (Shift lock control unit assembly)
|
| Tester Connection
|
Condition
|
Specified Condition
|
| 1 (SFTD) - 2 (E)
|
Shift lever held in"-"(Downshift)
|
Below 1 Ω
|
| Shift lever not in"-"
|
10 kΩ or higher
|
| 3 (SFTU) - 2 (E)
|
Shift lever held in"+"(Downshift)
|
Below 1 Ω
|
| Shift lever not in"+"
|
10 kΩ or higher
|
Shift Paddle Switch
| for LH
|
2 (SFTD) - 3 (ECC)
|
Pull continuously "-" (Down shift)
|
Below 2.5 Ω
|
| 2 (SFTD) - 3 (ECC)
|
Release "-" (Down shift)
|
1 MΩ or higher
|
| 2 (SFTD) - 4 (ECC1)
|
Pull continuously "-" (Down shift)
|
Below 2.5 Ω
|
| 2 (SFTD) - 4 (ECC1)
|
Release "-" (Down shift)
|
1 MΩ or higher
|
| for RH
|
3 (SFTU) - 2 (ECC1)
|
Pull continuously "+" (Up shift)
|
Below 2.5 Ω
|
| 3 (SFTU) - 2 (ECC1)
|
Release "+" (Up shift)
|
1 MΩ or higher
|