| Engine stall speed | D | 2400 +/- 400 rpm | |
| Secondary Oil pressure (Throttle valve fully open)*1 | |||
| Engine stall speed
2400 +/- 400 rpm |
D | 4.4 to 6.5 MPa
(44.9 to 66.3 kgf/cm2, 638 to 943 psi) |
|
| R | 4.4 to 6.8 MPa
(44.9 to 69.3 kgf/cm2, 638 to 986 psi) |
||
| Time lag | N → D | Less than 1.2 seconds | |
| N → R | Less than 1.5 seconds | ||
| Engine idle speed (A/C off) | N | 600 to 700 rpm | |
| Shift schedule | |||
| D | |||
| Throttle valve position (100%) | 40 km/h (25 mph) | 4300 to 4900 rpm | |
| 70 km/h (43 mph) | 5000 to 5700 rpm | ||
| 100 km/h (62 mph) | 5700 to 6400 rpm | ||
| Throttle valve position (Constant opening angle)*2 | 40 km/h (25 mph) | 900 to 1400 rpm | |
| 70 km/h (43 mph) | 1300 to 1800 rpm | ||
| 100 km/h (62 mph) | 2100 to 2600 rpm | ||
| Throttle valve position (100%) | Accelerator pedal fully depressed above 70 km/h (43 mph) | 3000 rpm or over | |
| Lock-up point (Throttle valve opening 5%) | |||
| D | Lock-up On | 5 to 30 km/h (3 to 19 mph) | |
| Lock-up point (Throttle valve opening 0%) | |||
| D | Lock-up Off | 5 to 30 km/h (3 to 19 mph) | |
*1: Connect terminals 13 (TC) and 4 (GC) of the DLC3 when measuring the fluid pressure.
*2: Depress the accelerator pedal at a consistent angle to maintain the specified vehicle speed.
| Engine stall speed | D | 2400 +/- 400 rpm | |
| Secondary Oil pressure (Throttle valve fully open)*1 | |||
| Engine stall speed
2400 +/- 400 rpm |
D | 4.4 to 6.5 MPa
(44.9 to 66.3 kgf/cm2, 638 to 943 psi) |
|
| R | 4.4 to 6.8 MPa
(44.9 to 69.3 kgf/cm2, 638 to 986 psi) |
||
| Time lag | N → D | Less than 1.2 seconds | |
| N → R | Less than 1.5 seconds | ||
| Engine idle speed (A/C off) | N | 600 to 700 rpm | |
| Shift schedule | |||
| D | |||
| Throttle valve position (100%) | 40 km/h (25 mph) | 4300 to 4900 rpm | |
| 70 km/h (43 mph) | 5000 to 5700 rpm | ||
| 100 km/h (62 mph) | 5700 to 6400 rpm | ||
| Throttle valve position (Constant opening angle)*2 | 40 km/h (25 mph) | 800 to 1200 rpm | |
| 70 km/h (43 mph) | 1300 to 1800 rpm | ||
| 100 km/h (62 mph) | 2100 to 2600 rpm | ||
| Throttle valve position (100%) | Accelerator pedal fully depressed above 70 km/h (43 mph) | 3000 rpm or over | |
| Lock-up point (Throttle valve opening 5%) | |||
| D | Lock-up On | 5 to 30 km/h (3 to 19 mph) | |
| Lock-up point (Throttle valve opening 0%) | |||
| D | Lock-up Off | 5 to 30 km/h (3 to 19 mph) | |
*1: Connect terminals 13 (TC) and 4 (GC) of the DLC3 when measuring the fluid pressure.
*2: Depress the accelerator pedal at a consistent angle to maintain the specified vehicle speed.
| Dry fill | 6.4 liters (6.8 US qts, 5.6 Imp. qts) | Toyota Genuine CVT fluid FE |
| CVT oil pump type T oil seal depth | Standard | -0.2 to 0.2 mm (-0.00787 to 0.00787 in.) |
| Drive plate runout | Maximum | 0.30 mm (0.0118 in.) |
| Front drive shaft oil seal LH depth | Standard | 2.6 to 3.6 mm (0.103 to 0.141 in.) |
| Front drive shaft oil seal RH depth | Standard | -0.5 to 0.5 mm (-0.0196 to 0.0196 in.) |
| Transmission revolution sensor (NIN) resistance | ||
| 1 (NIN-) - 2 (NIN+) | 20°C (68°F) | 560 to 680 Ω |
| Transmission revolution sensor (NOUT) current | ||
| 1 (NOTO) - 2 (NOTB) | Low signal | 4 to 8 mA |
| High signal | 12 to 16 mA | |
| Transmission revolution sensor (NT) current | ||
| 1 (NTO) - 2 (NTB) | Low signal | 4 to 8 mA |
| High signal | 12 to 16 mA | |
| Park/neutral position switch resistance | ||
| 4 (B) - 9 (L) | Shift lever in P or N | Below 1 Ω |
| Shift lever not in P and N | 10 kΩ or higher | |
| 1 (RB) - 3 (PL) | Shift lever in P | Below 1 Ω |
| Shift lever not in P | 10 kΩ or higher | |
| 1 (RB) - 2 (RL) | Shift lever in R | Below 1 Ω |
| Shift lever not in R | 10 kΩ or higher | |
| 1 (RB) - 8 (NL) | Shift lever in N | Below 1 Ω |
| Shift lever not in N | 10 kΩ or higher | |
| 1 (RB) - 7 (DL) | Shift lever in D or M | Below 1 Ω |
| Shift lever not in D and M | 10 kΩ or higher | |
| Shift lock control unit assembly (w/ Smart entry and start system) | ||
| Wire harness | ||
| Tester Connection | Condition | Specified Condition |
| 4 (IG) - Body ground | Engine switch on (IG) | 11 to 14 V |
| Engine switch off | Below 1 V | |
| 8 (STP) - Body ground | Brake pedal depressed | 11 to 14 V |
| Brake pedal released | Below 1 V | |
| 7 (E) - Body ground | Always | Below 1 Ω |
| Shift lock solenoid | ||
| 1 (SLS+) - 2 (SLS-) | Always | 112 Ω |
| 4 (P) - 3 (E2) | Shift lever in P | 10 kΩ or higher |
| Shift lever not in P | Below 1 Ω | |
| Shift lock control unit assembly (w/o Smart entry and start system) | ||
| Wire harness | ||
| Tester Connection | Condition | Specified Condition |
| 1 (ACC) - Body ground | Ignition switch ACC | 11 to 14 V |
| Ignition switch off | Below 1 V | |
| 4 (IG) - Body ground | Ignition switch ON | 11 to 14 V |
| Ignition switch off | Below 1 V | |
| 5 (KLS+) - Body ground | Ignition switch ACC and shift lever in P | Below 1 V |
| Ignition switch ACC and shift lever not in P | 11 to 14 V | |
| 8 (STP) - Body ground | Brake pedal depressed | 11 to 14 V |
| Brake pedal released | Below 1 V | |
| 7 (E) - Body ground | Always | Below 1 Ω |
| Shift lock solenoid | ||
| 1 (SLS+) - 2 (SLS-) | Always | 112 Ω |
| 4 (P) - 3 (E2) | Shift lever in P | 10 kΩ or higher |
| Shift lever not in P | Below 1 Ω | |
| Transmission control switch (Shift lock control unit assembly) (for LHD) | ||
| Tester Connection | Condition | Specified Condition |
| 1 (SFTD) - 2 (E) | Shift lever held in"-"(Downshift) | Below 1 Ω |
| Shift lever not in"-" | 10 kΩ or higher | |
| 3 (SFTU) - 2 (E) | Shift lever held in"+"(Downshift) | Below 1 Ω |
| Shift lever not in"+" | 10 kΩ or higher | |
| Transmission control switch (Shift lock control unit assembly) (for RHD) | ||
| Tester Connection | Condition | Specified Condition |
| 1 (SFTU) - 2 (E) | Shift lever held in"+"(Downshift) | Below 1 Ω |
| Shift lever not in"+" | 10 kΩ or higher | |
| 3 (SFTD) - 2 (E) | Shift lever held in"-"(Downshift) | Below 1 Ω |
| Shift lever not in"-" | 10 kΩ or higher | |