Home › Drivetrain › C50 MANUAL TRANSMISSION / TRANSAXLE › DIFFERENTIAL CASE › from 2017.10
RM30M0E _52 Drivetrain _017090 C50 MANUAL TRANSMISSION / TRANSAXLE _0091177 DIFFERENTIAL CASE A

C50 MANUAL TRANSMISSION / TRANSAXLE  DIFFERENTIAL CASE  DISASSEMBLY  


PROCEDURE

Hide 33481X 1.REMOVE SPEEDOMETER DRIVE GEAR

a.
C283044

Remove the speedometer drive gear from the front differential case assembly with ring gear.


Hide 2.INSPECT FRONT DIFFERENTIAL SIDE GEAR BACKLASH

a.
C360040

Using a dial indicator, measure the front differential side gear backlash while holding the front differential pinion in the front differential case assembly with ring gear.

Standard backlash:

0.05 to 0.20 mm (0.00197 to 0.00787 in.)


If the backlash is not as specified, replace the front No. 1 differential side gear thrust washers.


Hide 41342A 3.REMOVE FRONT DIFFERENTIAL PINION SHAFT STRAIGHT PIN

a.
C360038

Using a 5 mm pin punch and a hammer, remove the front differential pinion shaft straight pin from the front differential case assembly with ring gear.


Hide 41342F 4.REMOVE FRONT NO. 1 DIFFERENTIAL PINION SHAFT

a.
C360036

Remove the front No. 1 differential pinion shaft from the front differential case assembly with ring gear.


Hide 41331F 5.REMOVE FRONT DIFFERENTIAL SIDE GEAR

a.
C360035

Remove the 2 front differential pinions, 2 front differential pinion thrust washers, 2 front differential side gear thrust washers and the 2 front differential side gears from the front differential case assembly with ring gear.

HINT:

Rotating each front differential side gear, remove the 2 front differential pinions and the 2 front differential pinion thrust washers.