Home › Drivetrain › C50 MANUAL TRANSMISSION / TRANSAXLE › DIFFERENTIAL CASE › from 2017.10
RM30M0E _52 Drivetrain _017090 C50 MANUAL TRANSMISSION / TRANSAXLE _0091177 DIFFERENTIAL CASE A

C50 MANUAL TRANSMISSION / TRANSAXLE  DIFFERENTIAL CASE  REASSEMBLY  


PROCEDURE

Hide 1. PRECAUTION

NOTICE:
·

All disassembled parts should be cleaned before reassembly.

·

Coat all of the sliding and rotating surfaces with gear oil before reassembly, and check that they move smoothly after reassembly.



Hide 41331F 2.INSTALL FRONT DIFFERENTIAL SIDE GEAR

a.
C360035

Coat the sliding and rotating surfaces of the 2 front differential side gears, 2 front differential side gear thrust washers, 2 front differential pinions and the 2 front differential pinion thrust washers with gear oil.


b.

Install the 2 front differential side gear thrust washers to the 2 front differential side gears.


c.

Install the 2 front differential side gears, 2 front differential pinions and the 2 front differential pinion thrust washers to the front differential case assembly with ring gear.

HINT:

Rotating each front differential side gear, install the 2 front differential pinions and the 2 front differential pinion thrust washers.



Hide 41342F 3.INSTALL FRONT NO. 1 DIFFERENTIAL PINION SHAFT

a.
C360036

Coat the front No. 1 differential pinion shaft with gear oil.


b.

Install the front No. 1 differential pinion shaft to the front differential case so that the hole for the front differential pinion shaft straight pin is aligned with the hole in the front differential case assembly with ring gear.


Hide 4.ADJUST FRONT DIFFERENTIAL SIDE GEAR BACKLASH

a.
C360040

Using a dial indicator, measure the front differential side gear backlash while holding one of the front differential pinions toward the front differential case assembly with ring gear.

Standard backlash:

0.05 to 0.20 mm (0.00197 to 0.00787 in.)


If the backlash is not as specified, replace the front differential side gear thrust washers.

Front Differential Side Gear Thrust Washer Thickness:
Part No. Thickness
mm (in.)
41361-22140 0.95 (0.0374)
41361-22020 1.00 (0.0394)
41361-22150 1.05 (0.0413)
41361-22030 1.10 (0.0433)
41361-22160 1.15 (0.0452)
41361-22040 1.20 (0.0472)


HINT:
·

Measure the thickness with a micrometer to select a proper thrust washer because the thrust washers do not have any distinguishing marks.

·

Select thrust washers of the same thickness for both the right and left sides.




Hide 41342A 5.INSTALL FRONT DIFFERENTIAL PINION SHAFT STRAIGHT PIN

a.
C360039

Using a 5 mm pin punch and a hammer, install the front differential pinion shaft straight pin to the front differential case assembly with ring gear.


b.
C360037

Using a chisel and a hammer, stake the front differential case hole.


Hide 33481X 6.INSTALL SPEEDOMETER DRIVE GEAR

a.
C283044

Install the speedometer drive gear to the front differential case assembly with ring gear.