Home › Drivetrain › K312 CVT › SHIFT PADDLE SWITCH › from 2017.10
RM30M0E _52 Drivetrain _052969 K312 CVT _0333890 SHIFT PADDLE SWITCH G

K312 CVT  SHIFT PADDLE SWITCH  INSPECTION  


PROCEDURE

Hide 84610F 1.INSPECT SHIFT PADDLE SWITCH (TRANSMISSION SHIFT SWITCH ASSEMBLY)

C207558C26
2.667,2.948 2.885,3.292 true 2.521,2.948 2.302,3.292 true 1.063,3.042 1.344,3.292 true 0.938,3.042 0.875,3.281 true 0.813,3.042 0.438,3.281 true 0.771,3.719 1.083,3.917 0.313,0.198 10 false *a 2.5,3.719 2.813,3.917 0.313,0.198 10 false *b 2.052,3.302 2.458,3.469 0.406,0.167 10 false SFTU 1.125,3.302 1.531,3.469 0.406,0.167 10 false SFTD 2.729,3.302 3.156,3.469 0.427,0.167 10 false ECC1 0.177,3.302 0.604,3.469 0.427,0.167 10 false ECC1 0.698,3.302 1.052,3.469 0.354,0.167 10 false ECC
*a Component without harness connected
(Shift Paddle Switch LH)
*b Component without harness connected
(Shift Paddle Switch RH)


a.

Check the resistance.

i.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
for LH:
Tester Connection Condition Specified Condition
2 (SFTD) - 3 (ECC) Pull continuously "-" (Down shift) Below 2.5 Ω
Release "-" (Down shift) 1 MΩ or higher
2 (SFTD) - 4 (ECC1) Pull continuously "-" (Down shift) Below 2.5 Ω
Release "-" (Down shift) 1 MΩ or higher

for RH:
Tester Connection Condition Specified Condition
3 (SFTU) - 2 (ECC1) Pull continuously "+" (Up shift) Below 2.5 Ω
Release "+" (Up shift) 1 MΩ or higher


If the resistance values are not as specified, replace the shift paddle switch (transmission shift switch assembly).