58910C
1.REMOVE REAR CONSOLE BOX ASSEMBLY
33820B
2.DISCONNECT TRANSMISSION CONTROL CABLE ASSEMBLY
Apply the parking brake and move the shift lever to N.
Disconnect the end of the transmission control cable assembly from the transmission floor shift assembly.
| *1 | Nut |
|
Rotate approximately 180° |
|
Pull out |
Rotate the nut of the transmission control cable assembly approximately 180° in the direction shown in the illustration, and while holding the nut, separate the transmission control cable assembly from the transmission floor shift assembly.
Rotating the nut too much will damage the internal spring, and the transmission control cable assembly will not be reusable. Do not turn the nut too far.
33550
3.REMOVE TRANSMISSION FLOOR SHIFT ASSEMBLY (for LHD)
Disconnect the 2 connectors from the transmission floor shift assembly.
Disengage the 3 clamps to separate the wire harness from the transmission floor shift assembly.
Remove the 4 bolts and transmission floor shift assembly from the body.
33550
4.REMOVE TRANSMISSION FLOOR SHIFT ASSEMBLY (for RHD)
Disconnect the 2 connectors from the transmission floor shift assembly.
Disengage the 3 clamps to separate the wire harness from the transmission floor shift assembly.
Remove the 4 bolts and transmission floor shift assembly from the body.