DTC CHECK/CLEAR (When Using GTS)
Check the DTCs.
Turn the ignition switch off.
Connect the GTS to the DLC3.
Turn the ignition switch to ON.
Turn the GTS on.
Read the DTCs following the prompts on the GTS. Enter the following menus: Chassis / ABS/VSC/TRC / Trouble Codes.
Check the details of the DTCs.
Click hereBrake>BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS>ANTI-LOCK BRAKE SYSTEM>DIAGNOSTIC TROUBLE CODE CHART
Clear the DTCs.
Turn the ignition switch off.
Connect the GTS to the DLC3.
Turn the ignition switch to ON.
Turn the GTS on.
Operate the GTS to clear the codes. Enter the following menus: Chassis / ABS/VSC/TRC / Trouble Codes.
Press the DTC clear button.
According to the display on the GTS, select the trouble code data display with the clear button.
END OF DTC CHECK/CLEAR
Turn the ignition switch to ON.
Check that the ABS warning light go off within approximately 3 seconds after turning the ignition switch to ON.