GENERAL
The deceleration sensor used for the airbag system is installed on the vehicle and calculates the deceleration rate of each part during a collision.
Depending on the situation, the airbag ECU assembly sends a deployment signal to each airbag based on the information from the sensor.
DEPLOYMENT CONDITION
FRONTAL COLLISION
Frontal collision signals are produced based on the information from the airbag ECU assembly and front airbag sensor.
In case of a frontal collision, the SRS ignition signal may be output after receiving an ON signal from the deceleration sensor built into the airbag ECU assembly even without a signal from the front airbag sensor.
Frontal collision signals are used to deploy the airbags and pretensioners in the illustration.
SIDE COLLISION (w/ Curtain Shield Airbag)
Side collision (Pattern 1) signals are produced based on the information from the airbag ECU assembly and side airbag sensor assembly.
Side collision (Pattern 2) signals are produced based on the information from the airbag ECU assembly and No. 2 side airbag sensor assembly.
Side collision signals are used to deploy the airbags in the illustration.