73470B
1.INSPECT REAR SEAT INNER WITH CENTER BELT ASSEMBLY RH (w/ Seat Belt Warning System)
| *a | Component without harness connected
(Rear seat inner with center belt assembly RH) |
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| 2 - 3 | Center tongue plate fastened | 10 kΩ or higher |
| Center tongue plate released | Below 1 Ω | |
| 4 - 5 | RH side tongue plate fastened | 10 kΩ or higher |
| RH side tongue plate released | Below 1 Ω |
If the result is not as specified, replace the rear seat inner with center belt assembly RH.