The front airbag sensor circuit consists of the airbag ECU assembly and front airbag sensor.
The front airbag sensor detects impacts to the vehicle and sends signals to the airbag ECU assembly to determine if the airbag should be deployed.
DTC B161B/1A is stored when a malfunction is detected in the front airbag sensor circuit.
| DTC No. | Detection Item | DTC Detection Condition | Trouble Area | Test Mode / Check Mode |
|---|---|---|---|---|
| B161B/1A | Front Center Airbag Sensor | ·
Front airbag sensor malfunction ·
Airbag ECU assembly malfunction |
·
Front airbag sensor ·
Airbag ECU assembly |
DTC does not correspond to check mode. |
| *A | for TMT Made without Curtain Shield Airbag |
| *B | for TMMIN Made |
| *C | for TMT Made with Curtain Shield Airbag |
| *1 | Front Airbag Sensor |
| *2 | Airbag ECU Assembly |
Turn the ignition switch off.
Disconnect the cable from the negative (-) battery terminal.
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.
Temporarily replace the front airbag sensor with a new one.
Connect the cable to the negative (-) battery terminal.
Turn the ignition switch to ON, and wait for at least 60 seconds.
Clear the DTCs stored in the memory.
Click hereVehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>AIRBAG SYSTEM>DTC CHECK / CLEAR
Turn the ignition switch off.
Turn the ignition switch to ON, and wait for at least 60 seconds.
Check for DTCs.
Click hereVehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>AIRBAG SYSTEM>DTC CHECK / CLEAR
| Result | Proceed to |
|---|---|
| DTC B161B/1A is not output | A |
| DTC B161B/1A is output | B |
Codes other than DTCs B161B/1A may be output at this time, but they are not related to this check.
Turn the ignition switch off.
Disconnect the cable from the negative (-) battery terminal.
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.
Reinstall the former front airbag sensor, and connect the connector.
A
B