Home › Vehicle Interior › LIGHTING (INT) › LIGHTING SYSTEM › 2017.10–2018.01
RM30M0E _58 Vehicle Interior _017112 LIGHTING (INT) _0090848 LIGHTING SYSTEM D

LIGHTING (INT)  LIGHTING SYSTEM  OPERATION CHECK  


CHECK ILLUMINATED ENTRY SYSTEM OPERATION (w/ Power Door Lock)


HINT:

The lights controlled by the illuminated entry system are as follows.

·

Engine Switch*1

·

Map Light Assembly (When switch is in DOOR position)

·

Room Light Assembly (When switch is in DOOR position)*2



*1: w/ Smart Entry and Start System

*2: for TMT Made


a.

Check the map light assembly and room light assembly*1.

*1: for TMT Made


i.

The operation and conditions are described below.

Operation Condition
Fade in and illuminate constantly Any door is opened when all doors are closed.
Illuminate for 15 seconds, and then fade out When any of the following conditions are met, the lights illuminate for 15 seconds, and then fade out:
·

The driver door is unlocked when the ignition switch is off with all doors closed and locked.

·

The ignition switch is turned from ON to off when all doors are closed.

·

All doors are closed after any door is opened when the ignition switch is off.


Fade out immediately When any of the following conditions are met, the lights fade out immediately:
·

The ignition switch is turned from off to ON when all doors are closed.

·

The driver door is locked when the ignition switch is off, all doors are closed and the driver door is unlocked.





b.

Check the engine switch.(w/ Smart Entry and Start System)

i.

The operation and conditions are described below.

Operation Condition
Fade in and illuminate constantly
·

Any door is opened when all doors are closed.

·

The headlight dimmer switch is in the tail position.

·

The engine switch is on (ACC or IG).


Illuminate for 15 seconds, and then fade out When any of the following conditions are met, the lights illuminate for 15 seconds, and then fade out:
·

The driver door is unlocked when the engine switch is off with all doors closed and locked.

·

The engine switch is turned from on (IG) to off when all doors are closed.

·

All doors are closed after any door is opened when the engine switch is off.

·

With the engine switch off, all doors closed and any of the doors unlocked, the headlight dimmer switch is moved from the tail position to off.*1


Fade out immediately When any of the following conditions are met, the lights fade out immediately:
·

The engine switch is turned from on (ACC) to off, or the engine is started, when all doors are closed.

·

The engine switch is turned from on (IG) to the engine started, when all doors are closed.

·

The driver door is locked when the engine switch is off, all doors are closed and the driver door is unlocked.

·

With all doors locked, the headlight dimmer switch is moved from the tail position to off, and then all doors are closed.

·

With all doors closed, the headlight dimmer switch is moved from the tail position to off, and then all doors are locked.



*1: However, when all doors are locked within 15 seconds, the lights that operate turn off.





CHECK BATTERY SAVING FUNCTION (w/ Power Door Lock)


HINT:

The lights controlled by the battery saving function are as follows:

·

Engine Switch*1

·

Map Light Assembly (When switch is in DOOR position)

·

Room Light Assembly (When switch is in DOOR position)*2



*1: w/ Smart Entry and Start System

*2: for TMT Made


a.

The operation and conditions are described below.

Operation Condition
The lights are turned off When the doors remain in the same condition for 20 minutes and the engine switch is off, the illumination turns off.*1
When the doors remain in the same condition for 20 minutes and the key is not in the ignition key cylinder, the illumination turns off.*2

*1: w/ Smart Entry and Start System

*2: w/o Smart Entry and Start System