Use the same procedure for the RH side and LH side.
The following procedure is for the RH side.
1. PRECAUTION
Be sure to read Precaution thoroughly before servicing.
Click hereVehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>AIRBAG SYSTEM>PRECAUTION
After turning the ignition switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) battery terminal notices before proceeding with work.
Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION
2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.
63310
3.REMOVE ROOF HEADLINING ASSEMBLY
62170A
4.REMOVE CURTAIN SHIELD AIRBAG ASSEMBLY
Check that the ignition switch is off.
Check that the cable is disconnected from the negative (-) battery terminal.
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.
| *a | Airbag Connector |
| *b | Airbag Connector Lock |
| *c | Protective Tape |
Using a screwdriver with its tip wrapped in protective tape, release the airbag connector lock and disconnect the airbag connector.
When disconnecting any airbag connector, take care not to damage the airbag wire harness.
Using needle nose pliers, remove the 6 pins from the 6 clips (A).
| *1 | Spacer | - | - |
| *a | Clip (A) | *b | Clip (B) |
| *c | Pin | *d | Claw |
| *e | Spacer Location | - | - |
Using 2 screwdrivers, disengage the 12 claws of 6 clips (A) to separate the 6 clips (A) from the vehicle body as shown in the illustration.
Separate the 6 clips (A) and curtain shield airbag assembly from the vehicle body as a unit.
While holding the curtain shield airbag assembly, remove the 3 bolts and disengage the 5 clips (B) to remove the curtain shield airbag assembly.
Remove the 6 clips (A) and 2 spacers from the curtain shield airbag assembly.