84810
1.INSPECT POWER WINDOW REGULATOR SWITCH ASSEMBLY
Check the resistance.
| *a | Component without harness connected
(Power Window Regulator Switch Assembly) |
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Switch Condition | Specified Condition |
|---|---|---|
| 1 (D) - 4 (SD) | UP | Below 1 Ω |
| 2 (B) - 7 (U) | Below 1 Ω | |
| 1 (D) - 4 (SD) | off | Below 1 Ω |
| 7 (U) - 3 (SU) | Below 1 Ω | |
| 7 (U) - 3 (SU) | DOWN | Below 1 Ω |
| 1 (D) - 2 (B) | Below 1 Ω |
If the result is not as specified, replace the power window regulator switch assembly.