Home › Vehicle Exterior › WINDOW / GLASS › WINDOW DEFOGGER SWITCH(for TMT Made) › 2017.10–2018.01
RM30M0E _59 Vehicle Exterior _017121 WINDOW / GLASS _0334618 WINDOW DEFOGGER SWITCH(for TMT Made) G

WINDOW / GLASS  WINDOW DEFOGGER SWITCH(for TMT Made)  INSPECTION  


PROCEDURE

Hide 55900A 1.INSPECT HEATER CONTROL AND ACCESSORY ASSEMBLY

a.

Check the resistance.

i.
B487209C01
2.26,2.646 2.688,2.646 true 0.719,2.479 1.146,2.479 true 1.333,2.406 1.813,1.813 true 1.792,0.813 2.229,0.438 true 2.771,2.573 2.927,2.771 0.156,0.198 10 false E 0.552,2.396 0.708,2.594 0.156,0.198 10 false B 1.865,1.729 2.021,1.927 0.156,0.198 10 false D 2.271,0.344 2.5,0.531 0.229,0.188 10 false *b 0.104,0.063 0.333,0.25 0.229,0.188 10 false *a
*a Component without harness connected
(Heater Control and Accessory Assembly)
*b Indicator


Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
7 (D) - 9 (E) Defogger switch: OFF 10 kΩ or higher
7 (D) - 9 (E) Defogger switch: ON Below 1 Ω


If the result is not as specified, replace the heater control and accessory assembly.



b.

Check that the indicator illuminates.

i.

Apply battery voltage to the heater control and accessory assembly and check that the indicator illuminates.

OK:
Measurement Condition Specified Condition
Battery positive (+) → 8 (B)
Battery negative (-) → 7 (D)
Indicator illuminates


If the result is not as specified, replace the heater control and accessory assembly.