Home › Vehicle Exterior › WINDOW / GLASS › REAR POWER WINDOW SWITCH(for TMMIN Made) › 2017.10–2018.01
RM30M0E _59 Vehicle Exterior _017121 WINDOW / GLASS _0334656 REAR POWER WINDOW SWITCH(for TMMIN Made) G

WINDOW / GLASS  REAR POWER WINDOW SWITCH(for TMMIN Made)  INSPECTION  


PROCEDURE

Hide 84810D 1.INSPECT REAR POWER WINDOW REGULATOR SWITCH ASSEMBLY

a.

Check the resistance.

i.
B345718C01
0.667,1.292 1.167,1.292 true 1.333,1.833 1.5,1.385 true 1.708,1.833 1.708,1.375 true 2.167,1.833 1.969,1.396 true 2.219,1.292 2.719,1.292 true 0.073,0.083 0.385,0.281 0.313,0.198 10 false *a 0.458,1.219 0.771,1.417 0.313,0.198 10 false SU 1.271,1.854 1.583,2.052 0.313,0.198 10 false U 1.677,1.854 1.99,2.052 0.313,0.198 10 false B 2.104,1.854 2.417,2.052 0.313,0.198 10 false SD 2.771,1.219 3.083,1.417 0.313,0.198 10 false D
*a Component without harness connected
(Rear Power Window Regulator Switch Assembly)


Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Switch Condition Specified Condition
1 (D) - 2 (SD) UP Below 1 Ω
3 (B) - 4 (U) Below 1 Ω
1 (D) - 2 (SD) OFF Below 1 Ω
4 (U) - 5 (SU) Below 1 Ω
4 (U) - 5 (SU) DOWN Below 1 Ω
1 (D) - 3 (B) Below 1 Ω


If the result is not as specified, replace the rear power window regulator switch assembly.