76871
1.REMOVE REAR SPOILER
76801
2.REMOVE BACK DOOR OUTSIDE GARNISH SUB-ASSEMBLY
81006
3.REMOVE CENTER STOP LIGHT SET
68131
4.REMOVE BACK DOOR GLASS
|
Protective Tape |
Apply protective tape to the installation area on the back door glass on the vehicle body.
| *a | Matchmarks |
Place matchmarks on the back door glass and vehicle body on the locations indicated in the illustration.
Matchmarks are not needed to be placed if the back door glass will not be reused.
Disconnect each connector.
| *1 | No. 1 Back Window Glass Spacer |
| *2 | No. 2 Back Window Glass Spacer |
| *a | Piano Wire |
Pass a piano wire between the vehicle body and back door glass from the interior.
Tie objects that can serve as handles (for example, wooden blocks) to both wire ends.
Cut off the adhesive by pulling the piano wire around the back door glass.
When separating the back door glass from the vehicle body, be careful not to damage the paint or interior and exterior ornaments.
Using suction cups, disengage the No. 1 back window glass spacer and No. 2 back window glass spacer to remove the back door glass.
68294C
5.REMOVE BACK DOOR GLASS ADHESIVE DAM
| *a | Back Side |
Using a scraper, remove the back door glass adhesive dam.
Be careful not to damage the back door glass.
Be sure to replace the back door glass adhesive dam with a new one.
75575J
6.REMOVE BACK WINDOW OUTSIDE LOWER MOULDING
| *a | Back Side |
Using a scraper, remove the back window outside lower moulding.
Be careful not to damage the back door glass.
Be sure to replace the back window outside lower moulding with a new one.
7.REMOVE BACK WINDOW MOULDING PAD
| *a | Back Side |
Using a scraper, remove the 2 back window moulding pads.
Be careful not to damage the back door glass.
Be sure to replace the back window moulding pad with a new one.
64818B
8.REMOVE NO. 1 BACK WINDOW GLASS SPACER
| *a | Back Side |
Using a scraper, remove the No. 1 back window glass spacer.
Be careful not to damage the back door glass.
Be sure to replace the No. 1 back window glass spacer with a new one.
64819B
9.REMOVE NO. 2 BACK WINDOW GLASS SPACER
Use the same procedure as for the No. 1 back window glass spacer.