85110
1.INSTALL WINDSHIELD WIPER MOTOR ASSEMBLY
Using a T30 "TORX" socket wrench, install the windshield wiper motor assembly with 2 bolts.
Apply MP grease to the crank arm pivot of the windshield wiper motor assembly.
Apply MP grease to the pivot of the windshield wiper motor assembly.
| *1 | Wiper Rod |
| *a | Pivot of the windshield wiper motor assembly |
Connect the wiper rod to the pivot of the windshield wiper motor assembly.
2.INSTALL WINDSHIELD WIPER MOTOR AND LINK ASSEMBLY
| *1 | Motor Grommet |
Slide the windshield wiper motor and link assembly as shown in the illustration and engage the motor grommet with the body.
Be careful not to damage the windshield glass when installing the windshield wiper motor and link assembly.
Install the windshield wiper motor and link assembly with the 2 bolts.
Connect the connector.
Engage the clamp.
55781E
3.INSTALL COWL TOP VENTILATOR LOUVER SUB-ASSEMBLY
Engage the 8 guides and 5 claws to install the cowl top ventilator louver sub-assembly.
Install the 2 clips.
53867
4.INSTALL FRONT FENDER TO COWL SIDE SEAL LH
Engage the 3 guides and 2 pins to install the front fender to cowl side seal LH.
53866
5.INSTALL FRONT FENDER TO COWL SIDE SEAL RH
Use the same procedure as for the LH side.
6.INSTALL FRONT WIPER ARM AND BLADE ASSEMBLY LH
| *a | Wiper Arm Serration |
When reusing the front wiper arm and blade assembly LH:
Clean the wiper arm serrations to remove any burrs, dirt, etc.
Do not grind down the wiper arm serrations.
| *a | Wiper Pivot Serration |
When reusing the wiper link assembly:
Clean the wiper pivot serrations with a wire brush.
Do not grind down the wiper pivot serrations.
Operate the wiper, and then stop the windshield wiper motor assembly in the automatic stop position.
| *a | Ceramic Dot |
Align the blade tip with the ceramic dot on the glass, as shown in the illustration.
Hold the wiper arm by hand while tightening the nut.
Install the nut on the front wiper arm and blade assembly LH.
7.INSTALL FRONT WIPER ARM AND BLADE ASSEMBLY RH
| *a | Wiper Arm Serration |
When reusing the front wiper arm and blade assembly RH:
Clean the wiper arm serrations to remove any burrs, dirt, etc.
Do not grind down the wiper arm serrations.
| *a | Wiper Pivot Serration |
When reusing the wiper link assembly:
Clean the wiper pivot serrations with a wire brush.
Do not grind down the wiper pivot serrations.
Operate the wiper, and then stop the windshield wiper motor assembly in the automatic stop position.
| *a | Ceramic Dot |
Align the blade tip with the ceramic dot on the glass, as shown in the illustration.
Hold the wiper arm by hand while tightening the nut.
Install the nut on the front wiper arm and blade assembly RH.
8.INSTALL FRONT WIPER ARM HEAD CAP
Use the same procedure for both sides.
Engage the 3 claws to install the front wiper arm head cap.