Home › Audio / Visual / Telematics › PARK ASSIST / MONITORING › CLEARANCE SONAR MAIN SWITCH › from 2017.10
RM30M0E _56 Audio / Visual / Telematics _068680 PARK ASSIST / MONITORING _0335046 CLEARANCE SONAR MAIN SWITCH G

PARK ASSIST / MONITORING  CLEARANCE SONAR MAIN SWITCH  INSPECTION  


PROCEDURE

Hide 84490A 1.INSPECT BACK SONAR OR CLEARANCE SONAR SWITCH ASSEMBLY

a.
E224422C35
1.198,1.854 1.458,1.469 true 2.281,1.875 1.99,1.458 true 0.156,0.125 0.469,0.323 0.313,0.198 10 false *a 2.177,1.896 2.635,2.094 0.458,0.198 10 false ECU 1.063,1.875 1.521,2.073 0.458,0.198 10 false IG
*a Component without harness connected
(Back Sonar or Clearance Sonar Switch Assembly)


Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
11 (IG) - 8 (ECU) Switch pushed Below 1 Ω
Switch not pushed 10 kΩ or higher


If the result is not as specified, replace the back sonar or clearance sonar switch assembly.


b.

Check that the back sonar or clearance sonar switch assembly indicator illuminates.

i.
E224422C36
0.979,1.823 1.271,1.448 true 1.604,1.802 1.469,1.458 true 0.167,0.156 0.479,0.354 0.313,0.198 10 false *a 0.875,1.844 1.188,2.042 0.313,0.198 10 false E 1.583,1.833 1.896,2.031 0.313,0.198 10 false IG
*a Component without harness connected
(Back Sonar or Clearance Sonar Switch Assembly)


Apply battery voltage to the back sonar or clearance sonar switch assembly connector and check operation of the back sonar or clearance sonar switch assembly indicator, as shown in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
Battery positive (+) → Terminal 11 (IG)
Battery negative (-) → Terminal 12 (E)
Switch pushed Back sonar or clearance sonar indicator illuminates
Switch not pushed Back sonar or clearance sonar indicator does not illuminate


If the result is not as specified, replace the back sonar or clearance sonar switch assembly.



c.

Check that the switch illumination illuminates.

i.
E224422C37
1.365,1.813 1.594,1.469 true 2.073,1.802 1.833,1.448 true 0.135,0.073 0.448,0.271 0.313,0.198 10 false *a 2.052,1.854 2.385,2.073 0.333,0.219 10 false ILL- 1.115,1.823 1.448,2.042 0.333,0.219 10 false ILL+
*a Component without harness connected
(Back Sonar or Clearance Sonar Switch Assembly)


Apply battery voltage to the back sonar or clearance sonar switch assembly and check that the switch illuminates.

OK:
Connection Specified Condition
Battery positive (+) → Terminal 10 (ILL+)
Battery negative (-) → Terminal 9 (ILL-)
Illuminates


If the result is not as specified, replace the back sonar or clearance sonar switch assembly.