Home › Audio / Visual / Telematics › AUDIO / VIDEO › REAR DOOR SPEAKER(for TMT Made) › 2017.10–2018.01
RM30M0E _56 Audio / Visual / Telematics _017106 AUDIO / VIDEO _0335088 REAR DOOR SPEAKER(for TMT Made) A

AUDIO / VIDEO  REAR DOOR SPEAKER(for TMT Made)  REMOVAL  


CAUTION / NOTICE / HINT

HINT:
·

Use the same procedure for both the LH and RH sides.

·

The procedure described below is for the LH side.



PROCEDURE

Hide 74250 1.REMOVE REAR ARMREST ASSEMBLY (w/ Power Window)

Hide 74250 2.REMOVE REAR ARMREST ASSEMBLY (w/o Power Window)

Hide 74271A 3.REMOVE REAR DOOR ARMREST BASE UPPER PANEL (w/ Power Window)

Hide 74271A 4.REMOVE REAR DOOR ARMREST BASE UPPER PANEL (w/o Power Window)

Hide 69260E 5.REMOVE REAR DOOR WINDOW REGULATOR HANDLE ASSEMBLY (w/o Power Window)

Hide 67604 6.REMOVE REAR DOOR TRIM BOARD SUB-ASSEMBLY

Hide 86160B 7.REMOVE REAR SPEAKER ASSEMBLY

a.
E290823

Disconnect the connector.


b.

Using a drill bit with a diameter of less than 5 mm (0.197 in.), drill out the 3 rivet heads as shown in the illustration.

NOTICE:
·

Do not touch the cone part of the rear speaker assembly.

·

Do not drill the rivet at an angle as this will cause damage to the drill and drill hole. Line up the drill and rivet, and carefully drill out the rivet head.

·

Be careful as the cut rivet will be very hot.




c.

Continue drilling and push out the remaining rivet fragments.


d.

Disengage the claw and guide to remove the rear speaker assembly.


e.

Using a vacuum cleaner, remove the rivet fragments and shavings from the inside of the door.