Home › Audio / Visual / Telematics › AUDIO / VIDEO › REAR DOOR SPEAKER(for TMMIN Made) › 2017.10–2018.01
RM30M0E _56 Audio / Visual / Telematics _017106 AUDIO / VIDEO _0335104 REAR DOOR SPEAKER(for TMMIN Made) A

AUDIO / VIDEO  REAR DOOR SPEAKER(for TMMIN Made)  REMOVAL  


CAUTION / NOTICE / HINT

HINT:

The procedure described below is for the LH side. Use the same procedure for both the RH and LH sides, unless otherwise specified.


PROCEDURE

Hide 69260E 1.REMOVE REAR DOOR WINDOW REGULATOR HANDLE ASSEMBLY (w/o Power Window)

Hide 74272A 2.REMOVE REAR DOOR ARMREST BASE UPPER PANEL (w/ Power Window)

Hide 74272A 3.REMOVE REAR DOOR ARMREST BASE UPPER PANEL (w/o Power Window)

Hide 67604 4.REMOVE REAR DOOR TRIM BOARD SUB-ASSEMBLY

Hide 86160B 5.REMOVE REAR SPEAKER ASSEMBLY

a.
E275696

Disconnect the connector.


b.

Using a drill bit with a diameter of less than 5 mm (0.197 in.), drill out the 3 rivet heads as shown in the illustration.

NOTICE:
·

Do not touch the cone part of the rear speaker assembly.

·

Do not drill the rivet at an angle as this will cause damage to the drill and drill hole. Line up the drill and rivet, and carefully drill out the rivet head.

·

Be careful as the cut rivet will be very hot.




c.

Continue drilling and push out the remaining rivet fragments.


d.

Disengage the 2 claws and remove the rear speaker assembly.


e.

Using a vacuum cleaner, remove the rivet fragments and shavings from the inside of the door.