86011R
1.INSTALL RADIO SETTING CONDENSER
Engage the claw and install a new terminal cover to the wire harness.
Make sure to hold the wire harness so that the crimping side of the terminal is facing up when installing the wire harness to the terminal cover.
Make sure not to bend the exposed wire when installing the wire harness to the terminal cover.
Do not use excessive force when inserting the wire harness into the terminal cover.
If the terminal cover has been deformed at installation, replace the terminal and terminal cover with new ones.
Engage the 3 claws and install the new terminal cover with wire harness and a new condenser.
Do not use excessive force when inserting the terminal cover into the condenser.
If the terminal cover has been deformed at installation, replace the terminal, terminal cover and condenser with new ones.
Engage the clamp and temporarily install a new radio setting condenser with wire harness.
Install the new radio setting condenser with the bolt.
62572A
2.INSTALL ROOF SIDE INNER LOWER GARNISH LH