89611
1.INSPECT ENGINE SWITCH
Check the resistance.
| *a | Component without harness connected
(Engine Switch) |
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Switch Condition | Specified Condition |
|---|---|---|
| 5 (SS1) - 6 (AGND) | Pushed | Below 1 Ω |
| 1 (SS2) - 6 (AGND) | ||
| 5 (SS1) - 6 (AGND) | Not pushed | 10 kΩ or higher |
| 1 (SS2) - 6 (AGND) |
If the result is not as specified, replace the engine switch.
Check the LED illumination.
Apply battery voltage between the terminals of the engine switch, and check the illumination condition of the engine switch.
| Condition | Specified Condition |
|---|---|
| Battery positive (+) → Terminal 9 (SWIL)
Battery negative (-) → Terminal 6 (AGND) |
Illuminates |
If the positive (+) lead and negative (-) lead are incorrectly connected, the engine switch indicator will not illuminate.
If the voltage is too low, the indicator will not illuminate.
If the result is not as specified, replace the engine switch.