Home › Engine / Hybrid System › 2NR-FE STARTING › ENGINE SWITCH(for RHD) › from 2017.10
RM30M0E _51 Engine / Hybrid System _053950 2NR-FE STARTING _0335434 ENGINE SWITCH(for RHD) G

2NR-FE STARTING  ENGINE SWITCH(for RHD)  INSPECTION  


PROCEDURE

Hide 89611 1.INSPECT ENGINE SWITCH

a.

Check the resistance.

i.
A295732C02
0.76,0.906 1.208,1.073 true 2.208,1.083 2.688,0.927 true 2.219,1.344 2.698,1.573 true 1.146,1.906 1.521,1.427 true 0.052,0.042 0.365,0.198 0.313,0.156 10 *a 0.458,0.823 0.917,1.021 0.458,0.198 10 SS1 2.75,0.854 3.208,1.052 0.458,0.198 10 SS2 2.781,1.531 3.396,1.729 0.615,0.198 10 AGND 0.938,1.927 1.365,2.125 0.427,0.198 10 SWIL
*a Component without harness connected
(Engine Switch)


Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Switch Condition Specified Condition
5 (SS1) - 6 (AGND) Pushed Below 1 Ω
1 (SS2) - 6 (AGND)
5 (SS1) - 6 (AGND) Not pushed 10 kΩ or higher
1 (SS2) - 6 (AGND)


If the result is not as specified, replace the engine switch.



b.

Check the LED illumination.

i.

Apply battery voltage between the terminals of the engine switch, and check the illumination condition of the engine switch.

OK:
Condition Specified Condition
Battery positive (+) → Terminal 9 (SWIL)
Battery negative (-) → Terminal 6 (AGND)
Illuminates


NOTICE:
·

If the positive (+) lead and negative (-) lead are incorrectly connected, the engine switch indicator will not illuminate.

·

If the voltage is too low, the indicator will not illuminate.



If the result is not as specified, replace the engine switch.