Home › Vehicle Exterior › DOOR / HATCH › BACK DOOR SUPPORT › from 2017.10
RM30M0E _59 Vehicle Exterior _017122 DOOR / HATCH _0116784 BACK DOOR SUPPORT A

DOOR / HATCH  BACK DOOR SUPPORT  REMOVAL  


CAUTION / NOTICE / HINT

HINT:
·

Use the same procedure for both the LH and RH sides.

·

The procedure described below is for the LH side.



PROCEDURE

Hide 68960B 1.REMOVE BACK DOOR STAY ASSEMBLY

a.
B470741C01
0.563,0.344 0.76,0.375 true 0.625,0.781 0.802,0.646 true 2.208,2.583 2.406,2.615 true 2.229,3.104 2.396,2.99 true 0.365,0.25 0.531,0.438 0.167,0.188 10 true *a 0.427,0.708 0.604,0.885 0.177,0.177 10 true *b 2.021,2.469 2.188,2.656 0.167,0.188 10 false *a 2.052,3.021 2.229,3.198 0.177,0.177 10 true *b
*a Protective Tape
*b Stop Ring


Using a screwdriver with its tip wrapped in protective tape, slightly raise the 2 stop rings, as shown in the illustration.

NOTICE:
·

Do not touch the rod of the back door stay assembly with gloves, to prevent fibers from adhering.

·

When foreign matter adheres to the rod, it prevents the rod from moving smoothly and reduces its holding power.




b.

Disengage the 2 ball joints and remove the back door stay assembly.

NOTICE:
·

Do not remove the stop rings from the back door stay assembly. Raise the stop rings just enough to allow the back door stay assembly to be disengaged.

·

Do not reuse a stop ring if it is removed from the back door stay assembly.




Hide 68946 2.REMOVE BACK DOOR DAMPER STAY UPPER BRACKET

a.
B470742

Remove the 2 bolts and the back door damper stay upper bracket.


Hide 68948 3.REMOVE BACK DOOR DAMPER STAY LOWER BRACKET

a.
B348630

Remove the 2 bolts and the back door damper stay lower bracket.