Use the same procedure for both the LH and RH sides.
The procedure described below is for the LH side.
68948
1.INSTALL BACK DOOR DAMPER STAY LOWER BRACKET
Clean the threaded portion on the vehicle body with a non-residue solvent.
Apply adhesive to the threads of the 2 bolts.
Toyota Genuine Adhesive 1324, Three Bond 1324 or equivalent
Install the back door damper stay lower bracket with the 2 bolts in the order shown in the illustration.
When installing, install with the direction indicated by the arrow in the illustration.
68946
2.INSTALL BACK DOOR DAMPER STAY UPPER BRACKET
Clean the threaded portion on the vehicle body with a non-residue solvent.
Apply adhesive to the threads of the 2 bolts.
Toyota Genuine Adhesive 1324, Three Bond 1324 or equivalent
Install the back door damper stay upper bracket with the 2 bolts in the order shown in the illustration.
When installing, install with the direction indicated by the arrow in the illustration.
68960B
3.INSTALL BACK DOOR STAY ASSEMBLY
Avoid touching the stroke portions of the rod as much as possible to prevent foreign matter from attaching to the stroke portions. Be sure to hold the cylinders while servicing.
Do not wear cotton gloves or other similar materials when handling the rod. Fibers may attach to the rod and result in gas leaks.
Do not apply any load to the cylinders in the horizontal direction, in order to prevent the rod from being deformed.
Install the back door stay assembly on the 2 ball joints.
Install the back door stay assembly while supporting the back door by hand.
Engage the 2 stop rings.