Home › Audio / Visual / Telematics › PARK ASSIST / MONITORING › TOYOTA PARKING ASSIST-SENSOR SYSTEM › from 2017.10
RM30M0E _56 Audio / Visual / Telematics _068680 PARK ASSIST / MONITORING _0335855 TOYOTA PARKING ASSIST-SENSOR SYSTEM D

PARK ASSIST / MONITORING  TOYOTA PARKING ASSIST-SENSOR SYSTEM  SYSTEM DESCRIPTION  


GENERAL


a.

This system uses rear center ultrasonic sensors to detect obstacles at the rear of the vehicle. If an obstacle is detected, the system then informs the driver of the distance between the sensor and obstacle by sounding a buzzer.



FUNCTION OF COMPONENTS


Component Function
Rear center ultrasonic sensor Detects the distance between the vehicle and an obstacle.
No. 1 clearance warning buzzer Sounds to inform the driver according to the distance to an obstacle
Back sonar or clearance sonar switch assembly
·

Operating this switch enables, disables or cuts off the operation of the Toyota parking assist-sensor system.

·

Illuminates to inform the driver while the Toyota parking assist-sensor system is on (the engine switch is ON and the back sonar or clearance switch assembly is on).


Clearance warning ECU assembly Judges the approximate distance between the vehicle and an obstacle based on the signals from the rear center ultrasonic sensors and sounds the No. 1 clearance warning buzzer.
Park/neutral position switch Transmits the shift lever R position signal to the clearance warning ECU assembly.
TAIL Relay Transmits the tail relay ON signal to the clearance warning ECU assembly and the back sonar or clearance switch assembly.


OPERATION EXPLANATION


a.

The operating conditions of the rear center ultrasonic sensors are as follows.

Installation Position Operating Condition
Rear Center Sensor
·

Engine switch is ON.

·

Back sonar or clearance switch assembly is on.

·

Shift lever is in R.



When the system operates, the clearance warning ECU assembly transmits ultrasonic waves from the rear center ultrasonic sensors. If these waves encounter an obstacle within one or more of the sensors ranges, the waves are reflected back to the sensors, which transmit them to the clearance warning ECU assembly.

Based on this information, the clearance warning ECU assembly sends signals to the No. 1 clearance warning buzzer. The approximate distance between the vehicle and the obstacle is then indicated by the buzzer sounds.

HINT:

Refer to Detection Range Measurement Inspection.

Click hereAudio / Visual / Telematics>PARK ASSIST / MONITORING>TOYOTA PARKING ASSIST-SENSOR SYSTEM>OPERATION CHECK