Home › Vehicle Interior › DOOR LOCK › DOOR CONTROL RELAY › from 2017.10
RM30M0E _58 Vehicle Interior _017110 DOOR LOCK _0335972 DOOR CONTROL RELAY G

DOOR LOCK  DOOR CONTROL RELAY  INSPECTION  


PROCEDURE

Hide 84930F 1.INSPECT ALL LOCK RELAY (DOOR LOCK CONTROL RELAY)

a.
B319588

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
3 - 4 Battery voltage applied to terminals 1 and 2 10 kΩ or higher
3 - 4 Battery voltage not applied between terminals Below 1 Ω
3 - 5 Battery voltage applied to terminals 1 and 2 Below 1 Ω
3 - 5 Battery voltage not applied between terminals 10 kΩ or higher


If the result is not as specified, replace the all lock relay (door lock control relay).


Hide 84930F 2.INSPECT UNLOCK RELAY (DOOR LOCK CONTROL RELAY)

a.
B319588

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
3 - 4 Battery voltage applied to terminals 1 and 2 10 kΩ or higher
3 - 4 Battery voltage not applied between terminals Below 1 Ω
3 - 5 Battery voltage applied to terminals 1 and 2 Below 1 Ω
3 - 5 Battery voltage not applied between terminals 10 kΩ or higher


If the result is not as specified, replace the unlock relay (door lock control relay).


Hide 84930F 3.INSPECT D-UNLOCK RELAY (DOOR LOCK CONTROL RELAY)

a.
B319588

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
3 - 4 Battery voltage applied to terminals 1 and 2 10 kΩ or higher
3 - 4 Battery voltage not applied between terminals Below 1 Ω
3 - 5 Battery voltage applied to terminals 1 and 2 Below 1 Ω
3 - 5 Battery voltage not applied between terminals 10 kΩ or higher


If the result is not as specified, replace the d-unlock (door lock control relay).