52592
1.REMOVE REAR BUMPER SIDE SEAL LH
Using a clip remover, remove the clip.
Remove the 2 screw grommets and rear bumper side seal LH.
52591
2.REMOVE REAR BUMPER SIDE SEAL RH
Use the same procedure as for the LH side.
3.REMOVE REAR BUMPER ASSEMBLY
|
Protective Tape |
Apply protective tape as shown in the illustration.
Remove the 2 clips.
Remove the 2 clips and 2 screws.
Disengage the 16 claws.
Disengage the 4 claws.
w/ Rear Fog Light:
Disengage the clamp to separate the wire harness.
Use the same procedure for the RH side and LH side.
Disconnect the connector.
Use the same procedure for the RH side and LH side.
Remove the rear bumper assembly.