Home › Vehicle Exterior › EXTERIOR PANELS / TRIM › REAR BUMPER(for Sedan without Rear Light) › 2017.10–2018.01
RM30M0E _59 Vehicle Exterior _017128 EXTERIOR PANELS / TRIM _0336519 REAR BUMPER(for Sedan without Rear Light) A

EXTERIOR PANELS / TRIM  REAR BUMPER(for Sedan without Rear Light)  INSTALLATION  


PROCEDURE

Hide 1.INSTALL REAR BUMPER ASSEMBLY

a.

w/ Rear Fog Light:

i.

Connect the connector.

HINT:

Use the same procedure for the LH side and RH side.



ii.

Engage the clamp to install the wire harness.

HINT:

Use the same procedure for the LH side and RH side.




b.

Engage the 4 claws to install the rear bumper assembly.


c.

Engage the 16 claws.


d.

Install the 2 clips and 2 screws.


e.

Install the 2 clips.


f.

Remove the protective tape.


Hide 52592 2.INSTALL REAR BUMPER SIDE SEAL LH

a.

Install the rear bumper side seal LH with the 2 screw grommets.


b.

Install the clip.


Hide 52591 3.INSTALL REAR BUMPER SIDE SEAL RH

HINT:

Use the same procedure for the RH side and LH side.