1.INSTALL FRONT BUMPER ASSEMBLY
w/ Fog Light:
Connect the 2 fog light assembly connectors.
w/ Daytime Running Light:
Connect the 2 daytime running light assembly connectors.
Engage the 10 claws to install the front bumper assembly.
Install the 2 clips.
Install the bolt.
Install the 6 screws.
Engage the 2 claws to install the pin hold clip.
Use the same procedure for the RH side and LH side.
Install the clip.
Use the same procedure for the RH side and LH side.
Remove the protective tape.
2.INSTALL RADIATOR GRILLE SUB-ASSEMBLY
Engage the 6 claws and install the radiator grille sub-assembly.
Install the hood center cushion.
Install the 2 clips.
53141F
3.INSTALL RADIATOR COVER
Install the radiator cover with the 8 clips.
4.ADJUST FOG LIGHT AIMING (w/ Fog Light)