Home › Drivetrain › DRIVE SHAFT / PROPELLER SHAFT › FRONT DRIVE SHAFT ASSEMBLY(for 2NR-FE) › from 2017.10
RM30M0E _52 Drivetrain _017092 DRIVE SHAFT / PROPELLER SHAFT _0335781 FRONT DRIVE SHAFT ASSEMBLY(for 2NR-FE) G

DRIVE SHAFT / PROPELLER SHAFT  FRONT DRIVE SHAFT ASSEMBLY(for 2NR-FE)  INSPECTION  


PROCEDURE

Hide 1.INSPECT FRONT DRIVE SHAFT ASSEMBLY

a.
C287111

Check that there is no excessive play in the radial direction of the outboard joint.


b.

Check that the inboard joint slides smoothly in the thrust direction.


c.

Check that there is no excessive play in the radial direction of the inboard joint.


d.

Check the boots for damage.


e.
C287112N01
1.396,1.615 1.854,1.813 0.458,0.198 10 false (A)

Check whether each drive shaft dimension (A) is within specification.

Dimension (A):
LH Side 583.6 to 587.6 mm (1.91 to 1.93 ft.)
RH Side 825.6 to 829.6 mm (2.71 to 2.72 ft.)


NOTICE:

Keep the drive shaft assembly level during inspection.