76866B
1.INSTALL NO. 2 REAR SPOILER RETAINER
Install the No. 2 rear spoiler retainer.
76872
2.INSTALL NO. 1 REAR SPOILER PROTECTOR
When installing the No. 1 rear spoiler protector, heat the No. 1 rear spoiler protector using a heat light.
| *a | Heated Part |
| *b | Heat Light |
Do not touch the heat light and heated parts, touching the heat light may result in burns.
Touching heated parts for a long time may result in burns.
| Item | Temperature |
|---|---|
| Rear Spoiler | 20 to 30°C (68 to 86°F) |
Do not heat the No. 1 rear spoiler protector excessively.
Clean the No. 1 rear spoiler protector installation surface with a non-residue solvent.
Apply primer to the No. 1 rear spoiler protector installation area on the rear spoiler.
Apply primer evenly so that there are no uncoated areas.
Remove the peeling paper on a new No. 1 rear spoiler protector while making sure not to touch the adhesive surface.
Install the No. 1 rear spoiler protector as shown in the illustration.
Press the No. 1 rear spoiler protector to install it.
Press the double-sided tape on the No. 1 rear spoiler protector firmly to ensure proper adhesion.
After the primer dries (3 minutes or more), install the No. 1 rear spoiler protector.
After applying primer, reapply primer after 24 hours elapse.
76873A
3.INSTALL REAR SPOILER PROTECTOR RH
When installing the rear spoiler protector RH, heat the rear spoiler protector RH using a heat light.
| *a | Heated Part |
| *b | Heat Light |
Do not touch the heat light and heated parts, touching the heat light may result in burns.
Touching heated parts for a long time may result in burns.
| Item | Temperature |
|---|---|
| Rear Spoiler | 20 to 30°C (68 to 86°F) |
Do not heat the rear spoiler protector RH excessively.
Clean the rear spoiler protector RH installation surface with a non-residue solvent.
Apply primer to the rear spoiler protector RH installation area on the rear spoiler.
Apply primer evenly so that there are no uncoated areas.
Remove the peeling paper on a new rear spoiler protector RH while making sure not to touch the adhesive surface.
Install the rear spoiler protector RH as shown in the illustration.
Press the rear spoiler protector RH to install it.
Use the same procedure for the RH side and LH side.
Press the double-sided tape on the rear spoiler protector RH firmly to ensure proper adhesion.
After the primer dries (3 minutes or more), install the rear spoiler protector RH.
After applying primer, reapply primer after 24 hours elapse.
76898
4.INSTALL REAR SPOILER SIDE PROTECTOR LH
Clean the attachment surface.
Using a non-residue solvent, clean the attachment surface.
Install a new rear spoiler side protector LH to a new rear spoiler.
Install the 2 screws.
76897
5.INSTALL REAR SPOILER SIDE PROTECTOR RH
Use the same procedure as for the LH side.