Home › Vehicle Exterior › EXTERIOR PANELS / TRIM › REAR SPOILER(for Hatchback) › from 2017.10
RM30M0E _59 Vehicle Exterior _017128 EXTERIOR PANELS / TRIM _0336569 REAR SPOILER(for Hatchback) A

EXTERIOR PANELS / TRIM  REAR SPOILER(for Hatchback)  INSTALLATION  


PROCEDURE

Hide 76871 1.INSTALL REAR SPOILER

a.

Clean the attachment surface.

i.

Using an infrared light, heat the double-sided adhesive tape remaining on the vehicle body.

Heating Temperature
Item Temperature
Vehicle Body 40 to 60°C (104 to 140°F)

CAUTION:

Do not burn yourself on the hot vehicle body or with the infrared light.


NOTICE:

Do not heat the vehicle body excessively.



ii.

Using a piece of cloth, rub the remaining double-sided tape off the rear spoiler while it is hot from the infrared light.


iii.

Using a non-residue solvent, clean the attachment surface.

NOTICE:

Installing the rear spoiler while any double-sided tape remains on the vehicle body may cause adhesion failure. Therefore, completely remove the double-sided adhesive tape.




b.

Engage the clip and 2 claws to install the rear spoiler.


c.

Install the 4 bolts.

Torque:
5.5 N*m (56 kgf*cm, 49 in.*lbf)


Hide 76894D 2.INSTALL REAR SPOILER COVER LH

a.

Engage the 3 claws and install the rear spoiler cover LH.

HINT:

Use the same procedures for the opposite side.



Hide 76893A 3.INSTALL REAR SPOILER COVER RH

a.

Engage the 3 claws and install the rear spoiler cover RH.

HINT:

Use the same procedures for the opposite side.