Use the same procedure for the RH and LH sides.
The procedure described below is for the LH side.
62506C
1.REMOVE QUARTER PILLAR COVER SUB-ASSEMBLY
|
Protective Tape |
Apply protective tape to the vehicle body in the area around the quarter pillar cover sub-assembly.
Disengage the 2 clips in the position shown in the illustration.
Disengage the 4 guides, slide the quarter pillar cover sub-assembly in the direction shown by the arrow in the illustration and remove it.
Using a clip remover, remove the 4 clips.
Remove the 2 clips.
75554E
2.REMOVE QUARTER GARNISH MOULDING
Remove the quarter garnish moulding.